THE GRAGE STOP GDR12PW2ANHJ GRAGE STOP REMOTE CONTROL User Manual
- June 5, 2024
- THE GRAGE STOP
Table of Contents
THE GRAGE STOP GDR12PW2ANHJ GRAGE STOP REMOTE CONTROL
INSTRUCTIONS TO PROGRAM A REMOTE
- Press and release the learn button on the back of the motor unit. The light will illuminate for 30 seconds. This indicates the unit is in programming mode.
- Within 15 seconds press the button you wish to program on the remote control.
- You will hear an audible click and/or the light on the motor unit will turn off indicating the remote successful programming.
Repeat steps 1-3 for ang additional remotes you wish to program. Wait 60 seconds
before programming another remote control.
INSTRUCTIONS TO ERASE ALL CODES FROM MEMORY
Press and hold the purple learn button the back of the motor unit for 6
seconds or
until the light turns off.
WARNING
In order to prevent possible SERIOUS INJURY or DEATH from a moving gate or
garage doo keep remote controls out of the reach of children Only use the
remote control when the gate/garage door can be seen deary, s property
adjusted, and there are no obstructions to door travel Keep the gate garage
door in sight until is completely closed. Do not allow anyone to cross paths
with the gate garage door while moving or operating the remote control
Please take attention that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>