ricelake 192627 SYNERGY PLUS DIGITAL WEIGHT INDICATOR TECHNICAL User Manual
- June 5, 2024
- ricelake
Table of Contents
192627 SYNERGY PLUS DIGITAL WEIGHT INDICATOR TECHNICAL
User Manual
192627 SYNERGY PLUS DIGITAL WEIGHT INDICATOR TECHNICAL
**** | IMPORTANT | **** |
---|
Damage can occur to A/D circuitry if the SENSE parameter is not correctly
configured for the load cell cable used.
The SENSE parameter is set to 4-WIRE by default but must be changed to
6-WIRE for applications that use a 6-WIRE cable.
Configure the SENSE parameter using the front panel of the 680.
- Access setup mode by pressing the setup switch, and config displays.
- Press capacity displays.
- Press sense displays.
- Press to view the current wire setting for the SENSE parameter, displays.
- Press to change the setting and displays.
- Press to accept the SENSE parameter setting.
- Press to return to weigh mode.
Route the load cell cable to the J1 connector on the 680 CPU board and refer to the figures and table below for 4- and 6-wire cable wiring. For a 6-wire installation, the SENSE parameter must be set to 6-WIRE in the CONFIG menu.
SENSE Parameter set to 4-WIRE
Pin | Function |
---|---|
1 | + SIG |
2 | – SIG |
3 | + SENSE |
4 | – SENSE |
5 | + EXC |
6 | – EXC |
SENSE Parameter set to 6-WIRE
Note For a 4-wire installation leave pins 3 and 4 empty on the J1
connector.
Please refer to the 680 Technical Manual (PN 192627) for complete installation
instructions and for additional details on accessing setup mode and the CONFIG
menu, if needed.
PN 209029
Documents / Resources
|
ricelake 192627 SYNERGY PLUS DIGITAL WEIGHT INDICATOR
TECHNICAL
[pdf] User Manual
192627 SYNERGY PLUS DIGITAL WEIGHT INDICATOR TECHNICAL, SYNERGY PLUS DIGITAL
WEIGHT INDICATOR TECHNICAL, DIGITAL WEIGHT INDICATOR TECHNICAL, INDICATOR
TECHNICAL
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>