playLITE 15 STRING HARP Cordes par Gear4music User Manual
- June 5, 2024
- playLITE
Table of Contents
15 STRING HARP
USER MANUAL
INTRODUCTION
Thank you for purchasing a playlist 15 String Harp. To get the most out of your product, please read this manual carefully.
CONTENTS
- Harp
- Padded Gig Bag
- Tuning Lever
- Shoulder Strap
- User Manual
HARP TUNING
Use the supplied tuning lever to turn the tuning pegs and adjust the string tension when tuning the harp. Tightening the strings will raise the pitch of the string, and loosening the string will lower the pitch.
MAINTENANCE OF YOUR HARP
playlist harps include selected tonewoods to produce the best quality sound
and to ensure optimal performance of the instrument over time. As wood is a
living material, it is important to know that your instrument is subject to
humidity and temperature variations. The recommended climate conditions are
below:
Optimal temperature: 20°C ± 10°C (50°F – 86°F)
Optimal Humidity: 50% ± 15%
The harp must be kept away from heat sources and never exposed to direct
sunlight to avoid damage to the body and strings. It is always recommended to
keep the instrument in its included padded bag when not in use.
Clean your instrument only using a dry cloth, and remove all fingerprints from
the instrument after playing to protect the finish. Do not use solvents or
other domestic cleaners to clean or polish the instrument.
INITIAL TUNING
Tuning can be made by tightening and loosening the pegs on the top of the harp
(clockwise to tighten and anticlockwise to loosen) using the included tuning
key.
The tuning pegs are tapered meaning that they are wider at the end with the
tuning lever socket and narrower at the other end.
Please note that nylon strings can take a while to settle to their desired
tuning. To get the best results, and avoid snapping the strings, tune the harp
up a little, so there is some tension in the strings and leave for a few
hours. Then, over a series of repeated tunings, slowly raise the tension of
the strings up to the recommended tuning.
15 STRING RANGE
REPLACING THE STRINGS
Always replace the strings with like-for-like (same type and gauge) of harp strings. Replacement string sets are available from Gear4music. To replace the strings, follow the guide below:
-
Thread the strings upwards through the bottom of the sound hole and pull through until the metal ball ends of the strings reach the soundboard.
-
Thread the string into the hole of the tuning pin and pull in the direction indicated by the arrow.
-
Turn the pin clockwise, taking care to keep the string to the right of the hole and to the left of the bridge pin, as shown in the diagram below, and then follow the initial tuning instructions on page 5.
KETTLESTRING LANE | YORK | YO30 4XF | UNITED KINGDOM
If you have any more questions about this product, please do not hesitate to
contact the
Gear4music Customer Service Team on: +44 (0) 330 365 4444 or
info@gear4music.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>