Shenzhen Shennanhai Environmental Protection Technology BS-PINK2 Bluetooth Control Panel Instruction Manual
Table of Contents
Shenzhen Shennanhai Environmental Protection Technology BS-PINK2
Bluetooth Control Panel
Installation and use method
- Connect the two parts of the cloth-covered iron pipe (Figure 1 ).
- Put the iron pipe into the cloth cover and close the zipper (as shown in Figure 2).
- Connect the iron pipe of the base (as shown in Figure 3).
- Butt the seat part and the base part (as shown in Figure 4).
- Put on the pillow and buckle the button (see Figure 5).
- Install the mosquito net (Figure 6). You need to buckle 3 buttons, one on the left and right sides of the seat, and one under the top, and then pull the edge of the mosquito net to the seat under the seat (see Figure 7).
- Separate the seat and the base-pull the pin out by 2 mm by band, and then pull it out and separate by band. If it is too tight, you can pry it off with a flat-blade screwdriver (Figure 8).
- Swing to lock, move up to open the lock to swing, move down to lock and not to swing (See Figure 9).
- The cylindrical plug of the power cord is inserted into the circular power jack of the host, and the other end is inserted into a SV power output device such as a mobile phone charger or a power bank, an adapter, etc. (Figure 10). USB port, used to play music on U disk.
Control panel instructions
Host control panel
Please pull out the insulating film of the battery box before using the remote control.
Bluetooth instructions
- Long press the host music button for 3 seconds, or press the button on the remote control, The blue indicator light flashes. (As shown below)
- Click “Settings”-“Bluetooth” on the phone, enter the Bluetooth control page, search and click the Bluetooth name of “YaoLan” to connect. (As shown below)
- The Bluetooth connection is successful. (As shown below)
- Open the music APP on your mobile phone, search and play your favorite songs on the APP, switch songs, adjust the volume and other operations.
- If you want to connect Bluetooth to another mobile phone, please disconnect the Bluetooth on the original mobile phone first: click Q) to pop up the page and then click “disconnect”.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be u sed in portable exposure condition without restriction