JIRENO APT04 Portable Projector User Guide
- June 5, 2024
- JIRENO
Table of Contents
JIRENO APT04 Portable Projector
PRODUCT INTRODUCTION
Note: Type-C is not used as a power input port, please do not connect it to other external power supply devices,
REMOTE CONTROL
- Bluetooth Speaker Switch Button:
- Press once to turn on/off Bluetooth speaker mode,
- Near Focus Adjustment Button:
- The function of zoom in.
- Far Focus Adjustment Button:
- The function of zoom out.
- Menu Button :
- Press once to set more options which depend on the media source
- Settings Button:
- Press and hold for 2s to enter the system settings
- Voice Button:
- Press and hold to perform voice control.
- Remote Controller Pairing:
- Place the remote control close to the projector (within 20cm), press and hold the Left Direction Button and the Right Direction Button at the same time to pair with the projector,
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC radiation exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body