VECTRA KHAMSIN S1 Remote Control User Guide
- June 5, 2024
- VECTRA
Table of Contents
KHAMSIN S1 Remote Control
User Guide
Turn On Khamsin S1
Khamsin S1 remote control arrives with a 2 AAA battery blister inside a
polybag.
To turn on your Khamsin S1 remote control, please follow the instructions
below.
-
Turn ON your TV and your Set Top Box.
-
Remove your Khamsin S1 remote control and its batteries from the plastic bag.
-
Remove the remote’s battery lid.
-
Place the batteries on the Khamsin S1 remote control as indicated in the image above and replace the battery lid.
-
After inserting the batteries, wait a few seconds and the Khamsin S1 remote will be ready to operate the Set-Top-Box.
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
CAUTION
Risk of explosion if the battery is replaced by an incorrect type, disposal of
a battery into fire or a hot oven, or mechanically crushing or cutting of a
battery, that can result in an explosion; Leaving a battery in an extremely
high temperature surrounding environment that can result in an explosion or
the leakage of flammable liquid or gas; A battery subjected to the extremely
low air pressure that may result in an explosion or the leakage of flammable
liquid or gas.