ECO X Gear ACC-EXSNDRMTBLE Sound Extreme Remote Control User Guide
- June 5, 2024
- ECO X Gear
Table of Contents
ECO X Gear ACC-EXSNDRMTBLE Sound Extreme Remote Control
Remote Control
Pairing Your Remote Control
Before you use your Remote Control for the first time, pull and remove the
plastic tab at the bottom of the Remote Control. Your Remote Control should be
paired to your unit. IF NOT paired, please follow the steps below.
- l. Connect the Sound Extreme to a 72V power supply. (Refer to Connecting to 12VDC Power Supply for details.)
- Within 75 seconds, PRESS AND HOLD f!IQ for 3 seconds. Your Remote Control will be paired with your Sound Extreme.
- Verify that your remote control works by pressing the to see if the speakers light up.
If the speakers do not light up, unplug the 72V power supply, then repeat the above steps. Once the remote is paired with the Sound Extreme, it will remain stored in the SoundExtreme’s memory and should not need to be paired again.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the condition that this device does not cause harmful interference (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause hamful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
IC Caution:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>