IKEA 404.536.45 MITTLED LED Spotlight User Manual
- June 5, 2024
- Ikea
Table of Contents
404.536.45 MOTTLED LED Spotlight
User Manual
MITTLED
IMPORTANT SAFETY INSTRUCTIONS
For indoor use only. Regularly check the cord, the transformer, and all other
parts for damage. If any part is damaged the product should not be used.
Important information! Keep these instructions for future use.
CAUTION!
The light source of this product is non-changeable light diodes (LED). Do not
disassemble the product, as the light diodes can cause damage to the eyes. Do
not immerse in water. Cleaning Use a damp cloth, never a strong cleaning
agent.
CAUTION
To reduce the risk of fire, electric shock, or injury to persons: Use only
insulated staples or plastic ties to secure cords. Route and secure cords so
that they will not be pinched or damaged when the cabinet is pushed to the
wall. Position the portable cabinet light with respect to the cabinet so the
lamp replacement markings can be read during relamping. Not intended for
recessed installation in ceilings, or soffits. The low-voltage portable
cabinet light may be installed inside or under a kitchen cabinet or other
built-in furniture when:
1. The low-voltage Class 2 power supply is located outside the cabinet and is
not concealed; and
2. The line voltage power supply cord is not concealed or run through
openings in the cabinet, walls, ceilings, or floors. This requirement does not
apply to the wiring between the cabinet light and the power unit. The National
Electric Code (NEC) does not permit cords to be concealed where damage to
insulation may go unnoticed. To prevent fire danger, do not run cords behind
walls, ceilings, soffits, or cabinets where it may be inaccessible for
examination. Cords should be visually examined periodically and immediately
replaced when any damage is noted.
ATTENTION:
CAUTION:
Injury to persons and damage to the lamp and/or the mounting surface may
result if the lamp is pulled from the surface. To reduce the likelihood of
such injury or damage, mount only on a surface that is mechanically sound.
Use only IKEA LED drivers suited for this product. The total wattage of the
lamps connected to one LED driver must not exceed the maximum power stated on
that LED driver and never more than 30W.
WARNING
Deviation from the assembly instructions may result in a risk of fire or
electric shock.
LED
driver and power supply cord are sold separately.
© Inter IKEA Systems B.V. 2020
2020-05-27
AA-2243637-1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>