Masterbuilt Manufacturing MB20040221 Digital charcoal Griddle Grill Smoker User Manual
- June 5, 2024
- Masterbuilt Manufacturing
Table of Contents
Masterbuilt Manufacturing MB20040221 Digital charcoal Griddle Grill
Smoker
Assembly
Outer flange fits BEHIND rim of hopper opening.
Remove top heat shield screws. Slide bottom heat shield UNDER top heat shield.
Reinstall after lower screws (D) are installed.
Remove top heat shield screws. Slide bottom heat shield UNDER top heat shield.
Reinstall after lower screws (D) are installed
FRONT VIEW
REAR VIEW
install the antenna by screwing it onto the back of the panel. Then, turn the
top portion of the antenna as shown.
Install top screws (A) halfway into grill side wall. Place shelf over screw
heads, add lower screws (A), then tighten screws. 
INSTALLATION
Connect the three cords from inside the grill to the digital control panel.
Note that the prongs of the circled plug differ in size, with the larger one
being the negative charge and the smaller one being the positive charge. Make
sure to match the size of the prong with the size of the slot when plugging it
into the control panel. This should not require much force. Connect the power
cord last. 
Stand grill upright and lock both casters for stability.
Note: Ensure screws/nuts on legs and bottom shelf are tight
.
Remove hex nut and washer from temperature gauge, then reinstall as
illustrated. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>