VIVITAR VZ40031W true wireless Bluetooth earphones User Manual
- June 5, 2024
- Vivitar
Table of Contents
VIVITAR VZ40031W true wireless Bluetooth earphones
IN THE BOX
TAKE A LOOK
CHARGING
Powering On/ Bluetooth Pairing
(When the earphones are not in the charging box)
Press&hold both power buttons simultaneously for 3-4 Seconds
(When the earphones are in the charging box just take them out and they will
power on automatically. 
Once your earphones are powered on the LED Indicator Lights will alternately
flash red and blue. After approximately 1-2 seconds, the light on one earphone
will continue flashing and turn off on the other earphone. This means both
earphones are pairecd together.
(If both earphones do not pair together after 10 seconds, Insert both of the
Earphones into the charging case to let them power off. then take them out to
power on again, and wait for them to pair automatically.
Check your phone’s Bluetooth settings menu. Make sure that Bluetooth is turned
ON.
Connect with the device listed as VZ40031W.
Controlling Your Earphones
One Click: Play/Pause/Answer Incoming Call/End Call Two Rapid Clicks: Redial
Last Number
Hold Right Earphone 1.5 Seconds: Next Song/Reject Incoming Call
Hold Left Earphone 1.5 Seconds: Previous Song/Reject Incoming Call
Three Rapid Clicks: Activate Siri/Google Voice Assistants
Hold 3-4 Seconds: Power Off (When Not Recieving a Call)
Using the Case
NOTE: Your earphones will automatically power off when inserted in the charging case.
Specifications
- Bluetooth Version: V5.0
- Earphone Battery: 40mAh 2
- Charging Case Battery: 350mAh
- Earphone Input: 5V 40 mA MAX
- Charging Case Input: 5V 350mA MAX Char
- Time for Earphnes: Approximately 1 Hour g
- Charging Time for Charging Case: Approximately 2 hours
- Playing time: Approximately 3 Hours (under 50% volume)
- Bluetooth Working range: 10M
2020 Sakar International 195 Carter Drive, Edison, NJ 08817
Keep Manual and All Relevant Information for Future Reference
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- If the equipment is connected to an outlet, connect it to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>