Shenzhen Nearbyexpress Technology Development TTCL02X Bluetooth LED Stand Light Remote control User Manual
- June 5, 2024
- Shenzhen Nearbyexpress Technology Development
Table of Contents
Shenzhen Nearbyexpress Technology Development TTCL02X Bluetooth LED Stand
Light Remote control
Wireless Control
A Bluetooth remote shutter is provided for easy shooting experience with both iOS and Android phones (effective coverage of 1 0m/30 feet). You can easily control the phone to take selfies or record videos using one hand.
- Toggle the switch to ON, the remote shutter is turned on with the LED indicator flashing blue quickly.
- Turn on the Bluetooth function on your phone and search for “Tao Tronics Selfie”, tap on the name to connect. Once connected, the LED indicator will turn off.
- Turn on Camera on your phone, and then press the corresponding Camera Button (iOS or Android) to take photos.
Note: If pairing failed or no operation is done in 10 minutes, the remote shutter will enter standby mode. Press the Camera Button once again to wake it up.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.