Inventec GIV100 Smart Audio Bar User Manual
- June 5, 2024
- Inventec
Table of Contents
Inventec GIV100 Smart Audio Bar
Read and follow all instructions in the documentation before you operate your system.
IN THE BOX
OVERVIEW
Safety Information
Plastic bag notice
DANGER: Plastic bags can be dangerous. Keep plastic bags away from babies and
children to avoid danger of suffocation.
Important Notes
- Familiarize yourself with the port layout on the back of the Smart Audio Bar.
- Connect the Smart Audio Bar power in port to the matching port on the Meet Compute System.
- The Smart Audio Bar should be placed on a level surface below your display.
- Rubber feet of the Smart Audio Bar should touch surface for correct orientation
Attention
- This device is intended for use in ambient temperatures between 0°C and 35°C (32°F and 95°F)
- Avoid using or storing next to a heat source, in direct sunlight or near water.
Wall Mount
- The device can only be mounted in horizontal orientation
- The device shall not be mounted higher than 2m from the floor or shall not be mounted higher than 75cm from a flat surface
- Make sure your device is turned off before installing your mount kit
Warnings Do not:
- Throw or immerse into water
- Heat to more than 100°C (212°F)
- Repair or disassemble
- Leave in an extremely low air pressure environment
- Leave in an extremely high-temperature environment
Input Rating
- Voltage: 54V⎓
- Current: 1.76A
Compliance Information
North America
Federal Communication Commission Notice
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: 1. this device may not
cause harmful interference. 2. This device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modification not expressly approved by the grantee of this device
could void the user’s authority to operate the equipment.
Compliance with the Radio Equipment Directive
Hereby, Lenovo (Singapore) Pte. Ltd., declares that the radio equipment type
GIV10L is in compliance with Directive 2014/53/EU. The full text of the system
EU declaration of conformity is available at the following Internet address:
https://www.lenovo.com/us/en/compliance/eu-doc
This radio equipment operates with the following frequency bands and maximum
radio-frequency power:
References
- Contactus - Lenovo Support US
- Anatel — Agência Nacional de Telecomunicações
- Lenovo Warranty Check/Lookup | Check Warranty Status | Lenovo Support US
- SupportPhoneList - Lenovo Support US
- dtsc.ca.gov/hazardouswaste/perchlorate
- Regulatory Compliance | Recycling | Lenovo US
- Product Recycling Programs - Japan | Lenovo US
- Lenovo EU Declaration of Conformity Compliance Information | Lenovo US
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>