ProSpec ELECTRONICS JBL-R4500 Marine Source Unit User Manual
- June 5, 2024
- PROSPEC Electronics
Table of Contents
ProSpec ELECTRONICS JBL-R4500 Marine Source Unit
Product Description
This radio features state-of-the-art Bluetooth technology allowing music to wirelessly stream from an audio source to the receiver you just purchased. Why Bluetooth? From a practical standpoint, Bluetooth enables your music device (if applicable) to be placed in a glove box, your overhead console, or even your pocket-places that are dry without having to install a separate docking station. In addition, Bluetooth audio streaming will work with any Bluetooth- enabled device, not just one brand of media. Once connected, you can use your receiver to control your media device and vice versa! Bluetooth has a range of approximately 30′, depending upon conditions, so once your boat is parked, feel free to control the stereo through your media device!
The JBL-R4500 incorporates the following features:
- AM/FM/WB/RBDS
- Bluetooth Audio Streaming
- USB input
- Auxiliary input
- Waterproof faceplate
- 4x50W Peak @ 4 ohms
- U.S. and European tuning
- Charging through USB
- 3 pair of RCA output
Troubleshooting
Note: In many respects, a stereo acts much like a computer and
occasionally requires a reboot. In the unlikely event of product malfunction,
a reset can usually fix the issue.
Reset: Press and hold MENU knob over 3s to display SETUP, or turn VOL knob at
Home Screen and push SEL at SETUP. Then turn VOL knob and push it at ABOUT, it
will display firmware information on the screen; press and hold SEL knob for
about 5s until Factory Reset appears on the display screen, then select [YES]
and press SEL knob to confirm your selection.
Installation
A mounting gasket has been added inside the package for convenience. Trace along the inside edge and this will be your cutout.
Mounting Illustration
- Please install this unit in the place you prefer.
- Use the mounting template and screw to fix the unit.
Product Description
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>