Shenzhen Huimei Shangpin Technology HMSP-700 Wireless CarPlay Adapter User Manual
- June 5, 2024
- Shenzhen Huimei Shangpin Technology
Table of Contents
Wireless carplay adapter
User Manual
product overview
this product is used to convert factory wired car play to wireless carplay
step for usage
-
Connect to vehicle wired car play USB port with included USB cable
-
turn on the ACC of the car to power on the wireless carplay adapter
-
find and connect the Bluetooth named “CarPlayBox-XXXX” with your mobile phone. “XXXX” is 4 digits ID. if you’re phone prompts a BlueTooth pairing request
please click “Pair”. see below photo -
After connecting to Bluetooth, wait for a A few seconds and your phone will prompt “Allow contacts and favorites to sync”, click “allow”, see below screenshot
-
Wait for a while, when the phone prompts “Use CarPlay with CarPlayBox_xxxx” click“Use CarPlay” see below screenshot
wait a few seconds, your car stereo system will automatically enter car play mode or manually enter car play mode
Troubleshooting
If the Bluetooth connection is unsuccessful, please find the “CarplayBox_xxxx”, click I, and select “Forget This Device”, see the below diagram, then turn off and turn on Bluetooth. finally, repeat the above steps 3~5
Warning statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>