HidrateSpark 3 Smart Water Bottle User Manual

HidrateSpark 3 Smart Water Bottle

Overview

A. Lid
B. Soft Grip Body
C. Sensor Stick
D. Finger L oop
E. Battery
F. Bottom Ring

ATTENTION

• Your Hidrate Spark bottle uses one CR2477 Lithium battery. During the battery replacement process these batteries represent choking hazard.
• Product is NOT designed for hot liquids. Use only with cold liquids.
• Adding ice can cause an inaccurate measurement.
• Not for use with carbonated or pulpy beverages.
• Prior to drinking, make sure the lid is properly threaded to the body and screwed on completely.
• DO NOT overfill. Fill liquids to the fill line or below to avoid accidental spilling.
• DO NOT microwave or freeze.
• DO NOT use cleaners containing bleach, chlorine, abrasives and/or harsh chemicals.
• DO NOT continue to use if product is damaged.
• DO NOT carry bottles containing liquid in bags to help prevent accidental opening.

BATTERY INSTRUCTIONS

• Turn bottle upside down and unscrew the battery cover from the base of the bottle.
• Once the battery cover is removed insert battery into sensor.
• The sensor will illuminate with a startup sequence.
• Lastly, secure the battery covers back on the base of the bottle. DO NOT overtighten the screw when reassembling. Overtightening may cause damage to the product.

CHECK LID & INSERT THE FINGER LOOP

• Make sure the arrow on the seal and on the inside of the lid are facing the same direction to prevent leakage.
• To attach the finger loop, slide it underneath the metal pin on the back of the lid and loop it through itself.

DOWNLOAD THE APP

• Download our free Hidrate Spark Smart Water Bottle App from the App Store or on Google Play.
• Check that you have an internet connection and your Bluetooth is turned on. Follow the steps in the app to create an account, set parameters for a personalized hydration goal, add your bottle to your profile, and set your push notifications and glow reminders.
• Set down your bottle after every refill and drink. Remember to sync the app near the bottle each day so your water is tracked correctly.

CLEANING INSTRUCTIONS

• Wash thoroughly before first use.
• RINSE IMMEDIATELY AFTER EACH USE with the lid in the open position.
• Lid and Bottom Ring are Top-Rack dishwasher safe.
• The Sensor Stick and Body of the bottle are HAND WASH ONLY.
• ALWAYS STORE BOTTLE WITH LID, BOTTOM RING and SENSOR STICK REMOVED to allow parts to dry completely.

FCC

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by HIdrateSpark may void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. In cases where the manual is provided only in a form other than paper, such as on a computer disk or over the Internet, the information required by this section may be included in the manual in that alternative form, provided the user can reasonably be expected to have the capability to access information in that form.

ISEDC

This device complies with Innovation, Science, and Economic Development Canada’s license-exempt RSS. Operation is subject to the following two conditions:

1. This device may not cause interference; and
2. This device must accept any interference, including interference that
   may cause undesired operation of the device

Radiation Exposure Statement:
This equipment complies with the IC RSS- 102 radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body

We’re here to support you.
If you ever need to contact us, here’s how:
Chat with us on our website: hidratespark.com
Email: support@hidrate.me
In App Settings > Help
For more information and best practices, please visit hidratespark.com/pages/guide to review the user manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>