RGMT X NSF BATTLEDRESS CHRONOGRAPH WATCH Instruction Manual

RGMT X NSF BATTLEDRESS CHRONOGRAPH WATCH

OVERVIEW

PLEASE READ THE FOLLOWING

BEFORE UNSCREWING THE CROWN

SCREW-DOWN CROWN
Screw-down crowns are used to ensure water resistance. ALWAYS be certain that your crown is securely screwed down ( Position [0] is secured. Positions [1], [2] and [3] are not secured for water resistance ). Do NOT unscrew your crown while you are in any environment where moisture is present.

USING THE SCREW-DOWN CROWN

DO NOT PULL THE CROWN UNLESS IT IS FIRST

TO UNSCREW: Turn the crown anti-clockwise until it turns freely without tension. GENTLY pull the crown out to the other desired positions for watch setting (see specific operating instructions on the following pages).

TO SCREW: Push the crown ALL THE WAY IN (towards the watch) THEN begin to turn clockwise until it is securely screwed down.

HOW TO SET THE TIME

1. Pull out the crown to the position [3]-(2nd click). (the watch stops).
2. Turn the crown until you reach the correct time.
3. Push and screw down crown back in the position [0]

HOW TO SET THE DATE

1. Pull out the crown to the position [2]-(1st click). (the watch continues to run).
2. Turn the crown until the correct date appears.
3. Push and screw down crown back in the position [0].

Please note: The date can be changed during the date changing phase between approx. 9:00 PM and 12:00 PM; please note that the date must be set to the date of the following day as in this case the automatic date changing does not occur at midnight

STOPWATCH FUNCTION

The stopwatch measures up to 12 hours

STANDARD MEASUREMENT

ACCUMULATED ELAPSED TIME MEASUREMENT

Restart and stop of the stopwatch can be repeated by pressing the button A.

SPLIT TIME MEASUREMENT

Measurement and release of split time can be repeated as many times as necessary by pressing the button B.

ADJUST THE CHRONOGRAPH HANDS TO ZERO POSITION

Example:
One or several chronograph hands are not in their correct zero positions and have to be adjusted (e.g. following a battery change).

1. Unscrew and pull out the crown to position [3]-(2nd click). (all chronograph hands are in their correct or incorrect zero position).
2. Keep push-buttons A and B depressed simultaneously for at least 2 seconds (the second counter hand rotates by 360º corrective mode is  activated).
3. Adjusting the second counter hand: Single step, push button A once Continuous. push & hold button A long

To adjusting the next hand push button B

Adjusting the minute counter hand (position 9h): Single step, push button A once Continuous. Push & hold button A long

WATER RESISTANCE

• The water resistance indicated on your timepiece serves only as a guide. Actual water resistance may vary depending on a number of important factors including temperature, water salinity, and actual use under water.
• The water resistance of your timepiece may eventually be compromised over time with general wear and tear andthe use of your watch under adverse conditions.
• Always remember to employ the screw down crown (if available) to maintain the water resistance of your timepiece. Warranty may be voided if the screw down crown has not been properly employed.
• Note that you should NEVER wear your watch in a jacuzzi, hot shower or steam room where steam may enter the case despite the watertight seals used to protect your watch.
• The steam may cause condensation inside your watch, which may affect and damage the inner workings of your watch – which would also not be covered by the warranty.

HOW TO ATTACH THE STRAPS

HOW TO CHANGE THE STRAPS TO NATO STRAP

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>