Bhevs WC800HOPI19 Wireless Charging Pad User Manual
- June 5, 2024
- Bhevs
Table of Contents
Bhevs WC800HOPI19 Wireless Charging Pad
Instruction
- Put your phone on a wireless charging pad directly and in the center of the charging pad.
- Check the phone if it was charged or not. You can check on the mobile phone screen. If the phone was not charged, please try to put your phone in the charging area again.
Mainly this WC800HOPI19 wireless charger can be used for mobile phone wireless charging. Also can charge all devices to meet WPC standards.
FCC, IC Compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer (or party responsible) for compliance could void the user’s authority to operate the equipment
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF Radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunction with any other antenna or transmitter. This
equipment should be installed and operated with a minimum distance of 2 cm
between the radiator and your body.
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 2 cm between the radiator & your body.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED
BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID
THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. This device contains a license-
exempt transmitter(s)/receiver that complies with Innovation, Science, and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to
the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.