simorr ST20 Pro Portable Selfie Stick Tripod User Manual
- June 5, 2024
- simorr
Table of Contents
simorr ST20 Pro Portable Selfie Stick Tripod
Wireless Connection
Fix the mobile phone to the phone holder of the tripod, long press the shutter
button of the remote control for 2 seconds to tum on, the green light will
flash.
Wireless pairing mode: tum on the Wireless on your phone. then search • simorr
ST20 Pro • and connect to It.
After successful pairing, the green light will go out, then press the shutter
button of the remote control to take pictures.
Remove Remote Controller:
The remote controller of this product is detachable. Please stretch out the
telescopic rod a little and then push up the remote controller to use it
independenUy.
The Wireless remote controller is rechargeable. Please remove the remote
controller to charge when its battery is low after long-time usage.
Bracket Rotation
First
Rotate the phone holder upward from the back of the product Until it forms a
7-shape with the handle part.
Second
Hold the handle part by one hand, and rotate the phone holder 180 degrees by
the other one.
Third
Tilt one side of your phone into the phone holder, then push the other side
into It and fix it
Bracket instruction
First
Press the triangular safety lock button at the bottom of the product to enable
the unfolding mode.
Second
Hold the middle of the selfie stick by one hand, and hold the top of the pull
rod by the other hand to pull out the pull rod.
Notes
Tripod legs will be automatically released and closed when stretch and retract
the telescopic rod. Please do not put your hands directly on the surface of
tripod legs to avoid being pinched.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance
could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
FCC ID: 2AZWI-3595LEQI
IC STATEMENT:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1.) This device may not cause interference, and
2.) This device must accept any interference, including interference that may
cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>