SKIDZ RC XTYF835 2.4G RC Helicopter Instruction Manual
- June 5, 2024
- SKIDZ RC
Table of Contents
SKIDZ RC XTYF835 2.4G RC Helicopter
INCLUDED
ASSEMBLY TRANSMITTER
Install batteries: open the cover of the battery case, and insert 4 batteries
(size 1.5V AA) properly followed by the polar indicator. (Batteries to be
purchased).
USING INSTRUCTIONS FOR CHARGING POWER BATTERIES
First tum off the power switch of the helicopter, insert the USB plug of the charging cable into the USB socket of the computer and connect the other end of the plug to the charging socket of the helicopter. When charging, the LED light will light up, when the charging is completed, the LED light will go out, and the charging time is about 120-180 minutes.
ENVIRONMENT FOR FLIGHT
- Fly on a sunny day, without wind.
- Do not fly in extreme temperature.
- Do not fly in temperature above 113 degrees Fahrenheit /45 degrees centigrade or below 50 degrees Fahrenheit /10 degrees cen ti grade.
- Flying in extreme heat and/of cold will afect performance and may damage the model.
- 2 Do not fly in strong wind.
- Windy conditions wil limit or disturb the lying control
- In very windy conditions, your helicopter may become lost and/or damaged.
- Select a large, wide-open area for fying, and make sure is no obstructions, Animals or people nearby.
READY TO FLY
- Lay your helicopter onto the ground, and turn on the power switch, and the indicator lights.
- Leave the helicopter at least two meters away, while the tail is aimed at you.
- Check that the helicopter is far away frow the crowd, animals s and other obstructions.
- Pull the antenna of the remote controller to the longest and make sure the accelerator is at the minimum position. Tum on the remote control, tum to full throttle and reset, the indicator light will be always on. This time you can use the remote controller and prepare for taking of.
CONTROL METHOD
SPECIAL PROMPT
If the helicopter flies, rotating in the air without pulling the control
stick, then you can stop the fly, use screwdriver to adjust the potentiometer
on the chopper circuit board lightly til it is steady. Then adjust the hard
adjustment till it stop revoving.(f the helicopter is revolving in the air yet
you do not make action to the rudder, you can use the fine-turm-button on it
to make helicopter stop revolving and back to balance. If head of the
helicopter rotates clockwise, slowly touch the fine-turn button left of the
rudder to keep it balance, and vice versa. But when this adjust action is
useless, make helicopter landing, tum off the power on it. Then you tum on the
power of the helicopter and launch it, adjust the fine-turn button
again.)
FLYING PRACTICE
After enough practice, you can attempt folwing flying practice
TROUBLESHOOT AND DEAL WITH
SAFETY
WARNING
- This product is not a toy. Be sure that you can control and operata it safely and it is not suitable for chikdren under 14.
- If you dont have rich experience of controling and operating the product, you are suggested to leam it under the guidance of an experienced RC pilot. Manufacturer and dealer will not take any responsibilty of the using of the
- product.
- Debugging and flight should be carried out strictly in accordance with th Manual and make sure to keep your hands, face and body away form the revolving parts.
- Be sure to dy the helicopter indoors or in a windless outdoor place. Keep the moving parts away from the other people and objects.
- While stopping lying, off the switch of the transmitter power.
- Lithium poly mer battery is included with this heicopter. Users are required to obey the operating regulation of the Ithium battery otherwise it may cause accidents like buning, expoding and so on.
- Charge the pruduct by using the charging system included with the controller or the product’s special charge and power adapter.
- Take out the charge and the power adapter from the power outlet.
- To avoid accidents happening, never charge the product for a ong time without anybody’s watching.
- Never place the lithium battery in the direct sunlight or near fire. Never throw the battery into fire.
- Be sure to keep the battery in the dry environment.
- Never transport the battery and metal objects together.
- Never disassenble the battery.
- Never touch the charger or the power adapter with wet hands as to avoid accidents.
- While flying, do keep it away from the other electrical equioments, magnetic objects or radio devices so as to avoid accidents caused by interference and affection with each other.
- When battery power indicator light is twinkle. it shows that power of controller batteryis insuficient, please stop ftying and replace the controler batter.
- Guidelines for using lithium battery safely.
- In the case of not operating, charging the lithium battery may cause fire, personal injury and property loss. Users should be aware of the existence of risk whle using such products. it is impossible for the manufacturer, dealers
- and retailers to take the responsibility for the existence of accidents, Please carefully read the instruction of guidance, charging and using battery before usage of the product.
- If you are not sure how to charge the battery, please consult the local aeromodelling dealers. warning:
- Keep the batter away from the chikdren and pets. Users under the age of 18 shoukl be used in adult’s guardianship and users under the age of 14 are not suitable to operate the product.
PARTS
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the users authority t =operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.