MARKSMAN Camo PRO-X1 fastener User Manual

MARKSMAN Camo PRO-X1 fastene

Achieve a fastener-free surface on square decking with this easy and affordable hidden fastening system. MARKSMAN Tools automatically establish spacing between boards and direct CAMO Edge Screws into the edge of the board, leaving a smooth deck surface. Plus, the MARKSMAN system is backed by a CAMO warranty for use in leading deck boards.

Get to know your MARKSMAN® tools

WHICH TOOL SHOULD I USE

Setup for MARKSMAN Pro Tools

• A INSERT T-15 BIT
  Insert the T-15 driver bit into your drill. Do not use an impact driver.

• B IF YOU’RE PRE-DRILLING*, INSERT THE PRE-DRILL BIT
  Speed up the job by attaching the pre-drill bit to another drill.

• C ADJUST DRILL
  The recommended fastening speed for Edge fastening is 2500 RPM.

• D ADJUST SPACER TEETH
  Adjust the spacer teeth on the tool with the thumb dial to fit your board.

*Pre-drilling is required for capped composite and hardwoods.

How to fasten Edge Screws

BEFORE YOU BEGIN
Where Edge fastening with the MARKSMAN Pro Tools isn’t possible, use CAMO Premium Deck or Composite Screws. Go to page 41 for full instructions.

1. PLACE TOOL
   Place the tool on the board so it’s in line with the joist. If you are NOT pre-drilling, skip to step 3.

2. DRILL HOLE
   If pre-drilling, run the pre-drill bit through both screw channels.
   *Pre-drilling is required for capped composite and hardwoods.

3. LOAD SCREWS
   Load an Edge screw into both screw channels.

4. DRIVE
   Drive the screw in on both sides letting the screw do the work. The shoulder on the bit will stop the screw from overdriving.

Setup for MARKSMAN EDGE

• A ATTACH YOUR DRILL
  Attach the Drive Connection to your drill.
  NOTE: The MARKSMAN EDGE tool leaves no gap between boards. If you desire a gap, place secondary spacers before fastening.

How to fasten Edge screws

BEFORE YOU BEGIN
Where Edge fastening with the MARKSMAN EDGE isn’t possible, use CAMO Premium Deck or Composite Screws. Go to page 41 for full instructions.

1. LOAD A SCREW
   Load an Edge screw into the magnetized screw channel.

2. PLACE TOOL ON BOARD
   Align the screw channel with the joist, ensuring the face of the tool is flat.

3. DRIVE
   Drive the screw until it’s fully seated in the board.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>