M-Triangel M1 Bubble Remover Machine Instruction Manual
- June 5, 2024
- M-Triangel
Table of Contents
M-Triangel M1 Bubble Remover Machine Instruction Manual
Safety Rule
For your own safety, please read this manual carefully. Please familiar with the application and limitation of the machine, as well as the relevant potential risk.
- Please read this manual carefully before using the machine.
- Please keep the grounding good, bad grounding may result in equipment damage or endanger personal safety.
- It is strictly forbidden to open the electric box as nonprofessionals.
Specification
Voltage: AC220V (AC110V Optional)
Working Environment: 20-30℃,Clean, Dust-free
Heating Mode: Constant temperature heating
Equipment size: 35018088mm
Platform size: 350*280mm(7 inch )
Equipment weight: Net weight:6.58KG , Gross weight:6.82KG
Equipment Power: 300W
Features
- 7inch, small size, ultra-thin in addition to foam machine, powerful.
- High efficient , 30 seconds per piece.
- High intelligent equipment, one button automatic operation
Installation
Plug in, and put the vacuum pump triangle plug into the triangle port while
put the vacuum tube into the under port.
Install the muffler on the air compressor
- Press the top red button is turned off, up is start up.
- The right side is open valve, vertical is pumping, sideways is deflated.
Operation
Check setting on the screen
Laminating temperature: 40℃;
Vacuum time : 30s;
Laminating time: 30s;
Defaming temperature: 40℃.
Put the screen into the door, the cable on the bottom
Press the start button, about 30 seconds, you can press the stop button, take
out the screen.
Attention: Press the screen after turn the cable
Maintenance
Items | Notes |
---|---|
Platform and platen | Keep clean, no clutter inside. |
Life of machine | For keep it long use, turn off the power when not in use. |