EIP WRD5000 230v High Velocity Fan User Manual

EIP WRD5000 230v High Velocity Fan

INTRODUCTION

The user manual tells you how to operate the WRD-5000. Please read thoroughly before operating the unit. If you have any questions please contact our Customer Service Department at the address shown at the back of this section or phone 01388 602751
IMPORTANT Your WRD-5000 is packed in a plastic wrapping – please ensure that it is disposed of safely and where it will not be a danger to small children.

UNPACKING

Carefully remove the unit from its transit box and wrapping, and visually check for any signs of transit damage. If there are any signs of damage DO NOT attempt to operate the unit, call your supplier for advice. Retain the packaging for further use, or dispose of it considerately

OPERATION

The WRD-5000 should only be operated in the horizontal position and with the unit standing on a firm, level floor. The WRD-5000 is designed to blow large quantities of air across wet surfaces to speed up the drying process. The WRD-5000 should be positioned in the centre of the area to be dried. Connect the power cord to a suitable supply and the unit is ready for operation.

SWITCHING ON

The WRD-5000 ON/OFF switch is located on the side of the unit. To start the fan, set the switch to the ON position (I). Since the WRD-5000 has a considerably high suction, always ensure that the inlet grille is kept free of any obstruction during operation.

SWITCHING OFF

Set the ON/OFF switch to the OFF position (0). Turn off the power and disconnect. Do not use the supply cord to adjust or move the unit. Use the handle provided.
The unit is fitted with rubber feet to allow it to be stored in the vertical position.

ELECTRICAL CONNECTIONS

The wires in the mains lead are coloured in accordance with the following code:

• GREEN & YELLOW…………EARTH
• BLUE………………………….NEUTRAL
• BROWN……………………….LIVE

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your own plug, proceed as follows. The wire which is coloured Green and Yellow must be connected to the terminal marked E or by the Earth Symbol or coloured Green or Green and Yellow. The wire which is coloured Blue must be connected to the terminal in the plug marked with the letter N or is coloured Black. The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or is coloured Red.
You must safely dispose of the non rewireable plug once it has been removed from the flexible cord. It is dangerous to attempt to inset the plug into any electrical socket.
If the supply cord is damaged it must be replaced by qualified Ebac personnel or other similar qualified persons in order to avoid hazard.

CHANGING THE FUSE

Only 13 amp fuses that are ASTA approved to BS1362 should be used.

NON REWIREABLE PLUGS

The fuse cover must be refitted after replacement of the fuse.

SERVICE

Always turn off the power and unplug the unit before removing any guards. This machine should be serviced by qualified Ebac personnel or other persons having technical competence in servicing electrical equipment following the instructions in the Ebac Service Manual.

SPECIFICATIONS

SAFETY PRECAUTIONS

WARNING- THIS FAN IS NOT FLAMEPROOF

• DO NOT ALLOW CHILDREN TO PLAY WITH OR AROUND THE UNIT. ENSURE THE UNIT IS INACCESIBLE TO CHILDREN WHEN NOT ATTENDED.
• DO NOT USE THIS UNIT IN AN ENVIRONMENT CONTAINING FLAMMABLE FUMES
• DO NOT USE THIS UNIT IF THE CABINET OR POWER CORD IS DAMAGED
• DO NOT INSERT OBJECTS INTO ANY OF THE GRILLES ON THE MACHINE
• DO NOT COVER OR OBSTRUCT AIRFLOW FROM THE GRILLES
• DO NOT OPERATE THE UNIT WITH THE COVERS REMOVED
• DO NOT ATTEMPT ANY REPAIRS SHOULD THE UNIT FAIL TO OPERATE
• DO NOT STAND ON THE UNIT
•  DO NOT LIFT THE UNIT WHEN SWITCHED ON
• DO CHECK THE PLUG ON THE EQUIPMENT MATCHES THE SUPPLY
• DO USE THE UNIT FOR THE PURPOSE FOR WHICH IT WAS DESIGNED
• DO ENSURE THE POWER CORD AND SUPPLY IS EARTHED CORRECTLY
• DO USE A RESIDUAL CURRENT DEVICE “RCD” WHERE POSSIBLE
• DO KEEP THE UNIT DRY. NEVER USE A HOSE OR PRESSURE WASHER TO CLEAN THE UNIT.
• This appliance can be used by children from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the application in a safe way and understand the hazards involved.
• Cleaning and user maintenance shall not be made by children without supervision.

UK Head Office
Ebac Industrial Products Ltd St Helens Trading Estate Bishop Auckland
County Durham
DL14 9AD
Tel: +44 (0) 1388 664400 Fax: +44 (0) 1388 662590
www.eipl.co.uk
sales@eipl.co.uk

American Sales Office
Ebac Industrial Products Inc 700 Thimble Shoals Blvd. Suite 109, Newport News Virginia, 23606-2575
USA
Tel: +01 757 873 6800 Fax: +01 757 873 3632
www.ebacusa.com
sales@ebacusa.com

German Sales Office
Ebac Industrial Products Ltd. Gartenfelder Str. 29-37 Gebäude 35
D-13599, Berlin
Germany
Tel: +49 3043 557241
Fax: +49 3043 557240
www.eip-ltd.de
sales@eip-ltd.de

Our Address
Puravent, Adremit Limited, Unit 5a, Commercial Yard, Settle, North Yorkshire, BD24 9RH
Get In Touch
Call: 0845 6880112
Email: info@adremit.co.uk

References

• EIP Group - Industrial Dehumidifiers
• EIP Group - Industrial Dehumidifiers
• EIPL - Industrial Dehumidifiers

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>