WPM WELHOME PRO MS-130T Professional Milk Steamer Instruction Manual

WPM WELHOME PRO MS-130T Professional Milk Steamer

Safety Precautions
In order to prevent accidents or injures to the user, other people, and damage to property, please follow the instructions below

• Ensure that unit is used on a firm and flat surface.
• Never immerse the appliance in water or other liquids.
• Room temperature must range between 10° and 32°C (50°F and 90°F).
• Do not use the appliance under direct sunshine.
• Do not operate with empty water tank.
• Do not fill with any substance other than room temperature water.
• Do not touch the hot steam wand directly after operation.
• Please turn off the appliance when not in use otherwise it may result in danger.
• Please turn off the appliance and unplug the socket when unat-tended otherwise it may result in danger.
• Do not hang over the power cord at the edge of table or bench top or contact with any hot surface.
• This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concern-ing use of the appliance in a safe way and if they understand the hazards involved.
• Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.
• Keep the appliance and its cord out of reach of children less than 8 years.
• Children should be supervised to ensure that they do not play with the appliance.
• Appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• With any indication of malfunction (including power cord please stop using the appliance immediately to avoid hazard.
• Take it to the authorized service center for repair.
• Do not attempt to repair or change any parts by yourself.
• Please turn off and unplug the appliance before cleaning or maintenance.
• Clean the surface of the appliance with a dry cloth.
• Do not use corrosive detergent or solvent to clean.
• Do not swash the appli-ance with water.
• Please turn off and unplug the appliance when not in use, make sure the power is off before pulling out the plug and do not pull the cord.
• When the appliance is not in use for a prolonged period, please turn it off, unplug it, pack it well, and store it in dry cool place.
• Forbid to put flammable and explosive objects around the appliance, and do not use the appliance in an environment full of flammable gas and powder.
• Keep away from any fire and heat sources.
• Please put the power cord in the right place in order to avoid tripping the appliance over.
• Do not let the power cord hang over the edge of table counters or touch hot surfaces.
• Do not use your appliance with an extension cord unlessthe cord has been checked and tested by qualifiedtechnician or service person.
• Do not operate the appliance without load to avoid damaging the heat elements.
• Do not place hands under the steam nozzle directly, as it can lead to a scalding or injury.
• Please use suitable power source (220-240V~/50Hz).
• Never leave an appliance unattended while in use.
• Do not place ontop of any other appliances.
• The appliance is intended to be used in household and similar applications such as
  • Staff kitchen areas in shops, offices and other working environments.
  • Farm houses.
  • By clients in hotels, motels and other residential type environments.
  • Bed and breakfast type environments.
• Never clean the steam wand with an abrasive pad as this will damage the steam wand.
• Clean the steam wand immediately after use because dried milk may block the steam nozzle.
• Never clean the steam wand with an abrasive pad as this will damage the steam wand.
• Clean the steam wand immediately after use because dried milk may block the steam nozzle.
• The heating element surface is subject to residual heat after use.
• Do not touch the hot surface.
• The surfaces are liable to get hot during use.
• Do not install in rooms (kitchens) that are cleaned with jets of water.
• Do not clean the machine with jets of water.
• Operation and maintenance can only be done by trained personnel.

WARNING
Avoid spillage on the connector. Potential injury from misuse.

Failure to observe caution may result in personal injury
Attention
Users can refer online manual on WPM website  https://www.wpm.hk/en/news detail php id=22

Parts Names of MS-130T

1. Tank Lid
2. Removable Water Tank
3. Tank Entry
4. Steamer Body
5. Power Cord
6. Control Panel
7. Anti-heat Steam Wand
8. Main Power Switc
9. Pressure Outlet
10. Removable Drip Tray Cover
11. Removable Drip Tray
12. Stainless Steel Pitcher

High efficiency Heating System

This milk steamer contains a 4 bar / 0.4 MPa pressure pump for generating 1.5 bar / 0.15 MPa steam. With a high-efficient heater, it is capable of generating continuous and powerful steam.

Operation Guidelines of MS-130T

Control Panel

REMINDER

Press UP and  DOWN simultaneously to switch from Fahrenheit(° F) to Celsius(° C) conversion.

1. Switch on the Main Power Button Left lower side of machine.
2. Preheating Monitor shows —- for few minutes to represent preheating. When the machine is ready, previous target temperature.

Temperature Setting

Setting Preset Menu

REMINDER
Temperature setting range: 40° C- 90° C (104° F – 194° F)

• Pressing and holding P1/ P2button, the machine shows its preset temperature.
• Press UP  or DOWN  to adjust target temperature.
• Release  P1 / P2 button, machine beeps three times to show that saving is successful.
• Press P1/P2  button to set target temperature rapidly.

Setting Normal Target Temperature

Press  UP or DOWN  to adjust target temperature.

ATTENTION
Target temperature returns to previous setting after every use.,However, it will be rewritten after pressing P1/ P2button.

Start Milk Frothing

• Setting target temperature, press to start frothing.
• Liquid temperature will be shown in the display.
• During frothing, the display shows rising temperature.
• When the target temperature is reached, machine automatically stops dispensing steam.

REMINDER
User can stop steam dispensing with button.

WARNING
Hot Water Caution
Pressure outlet may release hot water after steam dispening.

After frothing

Machine returns to ready mode and display shows previous target temperature.

CAUTION
Do not remove steam wand from liquid before completely shutting down.

ATTENTION
The maximum time of steam release is 4 minutes. If the liquid does not reach the target temperature after 4 minutes, it will stop to release steam automatically.

Clean after use

Press to start flushing. Machine dispenses steam for 6 seconds to clean milk residual inside steam ward. Then wipe the steam wand clean with a damp cloth to clean milk residual on the surface of the steam ward.

ATTENTION
Prevent blockage of steam wand, users MUST flush the machine after each use.

WARNING
The surfaces are liable to get hot during use.

Cleaning and Maintenance

Descaling agent should be applied.

With unique dispensing pattern, the machine can be cleaned thoroughly. Cleaning agents are highly recommended to use. Check and ensure water tank is filled. Place a heat resistant large container below steam nozzle. Press and hold for 3 seconds to start cleaning mode and display shows  CL.

Press to start cleaning. Rhythmic hot water dispension program start.

Be careful of burns Warning
Hot water temperature 40° C – 60° C

Program stops when water tank is empty and display shows. User can refill water to keep cleaning or press and hold for 3 seconds to leave cleaning mode. The machine will restart automatically for next use.

REMINDER
Ensure all cleaning agent are consumed after cleaning.

Recycling and Disposal
Disposal of the Packaging
The packaging protects the unit against transport damage. The packing materials are selected according to the environmental compatibility and disposal related aspects and can therefore be recycled. The return of packaging into the material cycle saves raw material cycle saves raw material and reduces the waste volume.

Disposal of the Unit
At the end of its service life, this product cannot be disposed of in normal domestic waste. The symbol on the product and in the operating instructions point out to this fact. The materials are recyclable according to your marking. With the reuse, recycling or other forms of recycling of old equipment, you make an important contribution to the protection of our environment. Please ask your municipal administration for the disposal point.

Product Specifications

• Product name: Milk Steamer
• Product model: MS-130T
• Voltage and Power: 220V-240V~ 50-60Hz 1450W-1720W

Attention
Product Specifications, designs and dimensions are subject to change without prior notice.

Situations below are not accepted in the maintenance terms:

1. Formation of scale in thermoblock due to not using distilled water or inadequate and irregular cleaning.
2. Blocking in steam wand due to inadequate and irregular cleaning.

G.M.P. Industrial Co Ltd
Address: 7/F, Meyer Industrial Building 2 Chong Yip Street, Kwun Tong,Kowloon, Hong Kong

• Tel. No.: +852 23438211
• Fax: +852-23431647
• E-mail: welhome@gewcorp.com
• Website: www.wpm.hk

References

• WPM Welhome Pro
• WPM Welhome Pro

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>