Electrolux Z 930 Wet and Dry Vacuum Cleaner Owner’s Manual

: June 4, 2024
: Electrolux

Table of Contents

Electrolux Z 930 Wet and Dry Vacuum Cleaner
Product and Accessories
SAFETY INSTRUCTIONS
VACUUM CLEANER ASSEMBLING
Instructions for Use
- CLEANING TOOLS
Operating Procedure
- VACUUMING DUST
Maintenance
- DUST BAG REPLACEMENT
- How To Store Your Vacuum
TROUBLESHOOTING
Technical Data
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Electrolux Z 930 Wet and Dry Vacuum Cleaner

Please read these operating instructions before operating your vacuum cleaner.

Product and Accessories

CLEANING TOOLS

Electrolux Z 930 Wet and Dry Vacuum Cleaner-1

Floor Nozzle
Aluminium Telescopic Tubes
Flexible Hose
Tools on Board
On/Off Switch
Cable Rewind Button
Power Plug
Clasp
Big Wheel
Top Cover
Drum
Applicable to model Z 931 only.

Line drawings are solely for illustration purposes and are subject to variations from actual product.

Dear Customers,
Dear Customer, please read through these operating instructions carefully. Above all, please observe the safety instructions on the first few page of this booklet. Please keep these operating instructions for future reference and pass them on to any subsequent owner of this appliance.
The safety standards of Electrolux electrical appliances are in keeping with the recognized rules of technology and the laws governing the safety of appliances. Prior to operating this appliance please familiarise yourself with the following safety instructions:

SAFETY INSTRUCTIONS

Read all the instructions and only use the appliance for its intended purpose.
The appliance must be switched off before plugging or unplugging it from the wall socket. Do not pull on the electrical cord to remove the plug from the wall socket.
Always remove the plug from the wall socket before attempting any form of user maintenance or cleaning, as specified in this booklet.
Do not handle the plug with wet hands.
Do not operate the appliance with a damaged electrical cord or plug.
If the electrical cord is damaged it must be replaced by returning the product to an authorized Electrolux service center or similarly qualified person to avoid a hazard.
If the appliance has malfunctioned or been damaged in any manner return the appliance to the nearest authorized Electrolux service center for examination, repair or adjustment.
Do not carry or drag the appliance by the electrical cord.
Keep the electrical cord away from heat, oil, sharp edges and rough or hot surfaces, and do not run the appliance over the cord.
Hold onto the plug when rewinding the electrical cord to prevent the plug from whipping or hitting hard against the appliance.
An extension electrical cord may be used provided that it has a higher rating than the appliance. Please refer to the information provided on the appliance’s rating plate or consult your nearest authorized
Electrolux service centre.
To protect against electric shock do not immerse the electrical cord, plug or appliance in water or other liquids.
Do not expose the appliance to rain.
Do not use the appliance outdoors.
Never leave the appliance running unattended.
This appliance is not intended for use by people (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Store the appliance away from high heat sources.
Do not use this appliance to vacuum up the following
- Inflammable or combustible substances,
- Hard pointed objects,
- Hot ash, lighted cigarette ends or anything that is burning or smoking. Large quantities of fine dust e.g. lime, cement or plaster dust, toner dust from laser printers etc.
Do not operate this appliance in areas where the substances listed above may be present.
To prevent the reduction in air flow, ensure that all orifices/vents on this appliance are kept free from blockages and do not insert any objects into these orifices/vents.
Do not use without dust bag and filters in place.
If the motor overheats, it will turn off automatically. If this Occurs, press the on off button and wait for a few minutes before switching on again.
Extra care should be taken when vacuuming staircases.
It is dangerous to alter the specifications or modify the vacuum cleaner, nly use aCcessories recommended by Electrolux.
Under no circumstances should the customer attempt to repair the vacuum cleaner.
The vacuum cleaner should only be repaired and/or serviced by an authorized Electrolux service centre and only genuine Electrolux spare parts should be used. Failure to do So may render the warranty void.

This vacuum cleaner is for household Use only.

Important!
This vacuum cleaner must only be connected to a power supply whose voltage and frequency comply with the specifications given on the appliance rating plate.

Quick Guide
When taking the product out of its packaging, check for damages.

VACUUM CLEANER ASSEMBLING

Always remove the plug from the power supply before fitting or removing accessories. Before putting the applance into the service, please check if all filiters are inserted correctly.

Connecting vacuum cleaner
Fitting or removing the flexible hose to the air inlet (A)

Fit the flexible hose into the air inlet. Turn the hose grip clockwise until it clicks into position. To release, first remove the plug from the power socket. |
Detach the flexible hose firmly from the air intake duct by turning anti-clockwise.

Fitting or removing the flexible hose to the air outlet

Remove the filter cover and the fliter.
Fit the flexible hose into the air outlet.
Turn the hose grip clockwise until it clicks into position.
To release, first remove the plug from the power socket. Detach the flexible hose firmly from the air outlet duct by turning anti-clockwise.

Fitting the extension tubes and accessories

Fit the extension tube to the handle.
Fit the brush to the extension tube.

Fitting a chosen nozzle

Floor brush is intended for cleaning hard floors and carpets.
Crevice/upholstery nozzle is for cleaning corners and cushions.
Use the wet nozzle only for cleaning wet surfaces.

Instructions for Use

CLEANING TOOLS

The crevice tool, dusting brush and upholstery nozzle are stored on the accessories holder.

Floor Brush
Ideal for the daily cleaning on carpets and hard floors.

For the carpet

For the hard floor

Wet Nozzle
ldeal for absorbing water or liquid.

Wet nozzle to absorb water

Crevice Nozzle

The crevice nozzle can be used for cleaning corners, between cushions or difficult to reach places.

Dusting Brush

Dusting brush is used for the furniture, venation, blinds, books, lamp shades and shelves.

Upholstery Nozzle

The small brush is used for cleaning the sofa.

Operating Procedure

Before using the appliance, pull out a sufficient length of cord and insert the plug into the power supply.
Press the On/Off button to switch the unit on. To stop it, press the On/ Off button again.
Use the Electronic Power Switch to control the suction of the cleaner.
(Cord winder applies to model Z 931)
To rewind the cord, press the rewind button and guide the cord with hand to ensure that it does not whip causing damage. (Cord winder applies to model Z 931)

VACUUMING DUST

Before vacuuming dust, please make sure the body, motor housing, filter cylinder and attachments are dry.
Please ensure the filter cylinder is fitted.
Always operate the cleaner with dust bag installed. Undo the clasp and remove the top cover from the body. Secure the dust bag in its position by pushing down the bag collar in its slot.

ABSORBING WATER

Before you use the vacuum to absorb water or liquid, please make
Sure the filter cylinder is fitted on the motor housing.
Remove the dust bag from the vacuum cleaner.
You may fit in the wet nozzle or other cleaning tools.
The safety buoy will not work whenthe body is flled with liquid. Please switch off the unit and remove the top cover. Pour out the liquid.
If the appliance has fallen over, water may enter in to the motor. Ensure that there is no water inside the motor before operating again.

BLOWING DUST
Remove the filter grille from the blower position.
Fit the hose connection.
Once complete, remove the hose connection, fit the filter grille to its position and turn tightly.

Note : When the vacuum cleaner is working, the suction may get weak.
Now you should turn off the unit for a moment. If it still does not work, clean the body after turning off the unit. Continuous use of appliance may increase the motor temperature and may damage the unit.

Maintenance

DUST BAG REPLACEMENT

Note:
Before doing any type of cleaning or maintenance to the cleaner, always ensure that the cleaner is unplugged from the wall Socket.

ATter detaching the flexible tube,remove the top cover
Lift up the dust bag collar to remove from its slot.
When the dust bag is full, replace with a new one.
Replace the top cover and secure both latches on each sides

CLEANING FILTER

Note:

Filter must be cleaned at least twice a year or when it becomes visibly solid.
Disconnect from electrical outlet before cleaning filters.
Do not use a washing machine to rinse filiters.
Do not use hair dryer to dry flters.
Remove filter
Rinse filiter in lukewam water and dry the flter completely.
Replace the filter

How To Store Your Vacuum

Choose a storage location that is both safe and dry.
The vacuum comes with an onboard tool coupling for storing the floor nozzle, slide the parking clip onto the parking positions on the cleaner.
Keep the extension tubes, nozzles and hose together to avoid losing them.

TROUBLESHOOTING

In case of malfunction, check for the following probable reasons. Make the necessary Corections which may be performed at home. If the problem persists, consult the Electrolux Authorized Service Centre.

PROBLEM	POSSIBLE CAUSES	CORRECTIONS
The vacuum cleaner	The plug is not properly	Check the plug connection
does not start.	connected to the socket.	or try another socket.
Thermal protector	Press the ON/OFF button
activated due to motor	and wait 30 minutes for the
high temperature.	motor to cool off.

Filter indicator lights and stays on.

|

Dust bag is full.

The filters are clogged.

|

Replace disposable dust bag and check filters.

Clean or replace filters.

Filters are clogged.

| Replace the disposable dust bag.

Clean /replace filters.

Technical Data

For Z930 & Z931
220- 240V, 50/60Hz
Max Power (W): 160OW

MALAYSIA
Electrolux Home Appliances Sdn Bhd
Lot C6, No. 28, Jalan 15/22,
Taman Perindustrian Tiong Nam,
40200 Shah Alam, Selangor

Malaysia
Customer Care Hotline: 1300-88-11-22
Customer Care Services Tel: (+60 3) 5525 0800
Customer Care Services Fax: (+60 3) 5524 2521
Email: malaysia.customercare@electrolux.com
Website: www.electrolux.com.my

THAILAND
Electrolux Thailand Co Ltd
Electrolux Building
14th Floor 1910 New Petchburi Road
Bangkapi, Huay Kwang
Bangkok 10310
Thailand
Tel: +(66) 2 725 9100
Fax: +(66) 2 725 9299
Customer Care Services: +(66) 2 725 9000
Email: customercarethai@electrolux.com
Website: www.electrolux.co.th

VIETNAM
Electrolux Vietnam Ltd
Floor 9th, A&B Tower
76 Le Lai Street
Ben Thanh Ward – District 1
Ho Chi Minh City
Vietnam
Tel: +(84) 8 3910 5465
Fax: +(84) 8 3910 547o
Customer Care Services: 1800-58-8899
Email: vncare@electrolux.com
Website: www.electrolux.vn

SINGAPORE
Electrolux SEA Pte Ltd
1 Fusionopolis Place, Galaxis #07-10 (West Lobby)
Singapore 138522
Customer Care Hotline: +(65) 6727 3699
Fax: +(65) 6727 3611
Email: customer-care.sin@electrolux.com
Website: www.electrolux.com.sg

PHILIPPINES
Electrolux Philippines Inc.
12th Floor Cyber Sigma Building
Lawton Avenue, McKinley West,
Taguig City, Philippines 1634
Customer Care Hotline: +(63) 02 845-CARE (2273)
Toll Free (PLDT Only): 1-800 10 845-CARE (2273)
Email: wecare@electrolux.com
Website: www.electrolux.com.ph

INDONESIA
PT. Electrolux Indonesia
JI. Abdul Muis no. 34
Petojo Selatan, Gambir
Jakarta 10160, Indonesia
Tel:+(62) 21 5081 7300
Fax: +(62) 21 5081 7399
Customer Care Services: +(62) 0804 111 999
Email: customercare@electrolux.co.id
Website: www.electrolux.co.id
DEPDAG: 1.31.El12.01301.1016