KongRoad KR-088A Steam Styler Hair Straightener User Manual
- June 1, 2024
- KongRoad
Table of Contents
User Manual
KR – 088A
KR-O88A Steam Styler
Hair Straightener
SAFETY INSTRUCTIONS
WARNING – THIS APPLIANCE SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS,
BASINS OR OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS. i
This product is not suitable for use in bath or shower.
THE STYLER SHOULD BE UNPLUGGED FROM MAIN POWER | SUPPLY WHEN NOT IN USE [
- Do not leave the Styler unattended when switched on.
- Allow the Styler to cool down before storing it.
- Do not immerse in water or other liquids.
- Do not place Styler on soft material e.g. carpet, bedding, towels, rugs etc.
- Always ensure the voltage to be used corresponds to the voltage stated on the unit.
- Avoid allowing any part of the hot plates to contact the face, neck or scalp.
- Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
- Damaged cords can be dangerous. If the cord of this unit becomes damaged, discontinue use immediately, contact us for repair or replacement in order to avoid a hazard.
- We do not accept responsibility for damages to the product, persons or other items, caused by misuse, abuse or non- compliance of these instructions.
- Do not use any other liquid other than water in your Styler to avoid damage to unit.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental Capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
HOW TO FILE THE WATER TANK
STEAM RELEASE SETTING
There are 3 settings on the Steam Release Dial. Please see the underside of
the Styler. See diagram below.
The settings are:
To release the Steam turn the button
clockwise to the desired steam position.
*CAUTION: Note the Steam activates over 100°C/212°F As you start to use the Styler you will Notice steam start to come through the steam vents.
FEATURES & BENEFITS
FIG 1: Extra wide ceramic tourmaline plates I 1/4″.
FIG 2: 2.5 meter extra-long (8.2′)porfessional burn resistant cord.
FIG 3: 360°swivel cord.
FIG 4 Digital green LED light indicator.
FIG 5: Digital LED light temperature control heats up to 450°F/235
FIG 6: 6 digital temperature settings.
FIG 7: Separate ON’ OFF button with LED flashing light indicator.
FIG &: 5 conditioning steam vents.
FIG 9: Water tank.
FIG 10: Tank- lock switch.
FIG 11: 3 conditioning steam settings off/meds/high.
FIG 12: Plate locking switch for storage and trave.
FIG 13: Non-slip silicone block.
FIG 14: Heat- proof tp.
Dual voltage for travel one hour auto shut off.
INSTRUCTIONS FOR USE
- Before use, make sure hair 1s clean and tangle -free
- Fill the tank to your desired level with water. (Our product will have ±10°C temperature difference).
- Plug in the unit, press the N.OFF switch until LED light tums on.
- Temperature flash until desired temperature is reached and then the unit STOP flash when ready to use.
- Run the straightener through the entire length of the hair, without stopping.
- Repeat only twice per section to prevent hair damage.
STRAIGHTENING YOUR HAIR
STEP1 : Prep your hair. Make sure your hair is clean & tangle -free.
STEP2: This information below is geared at persons with medium & shoulder
length hair. Take a 2 wide x 1/4” thick section of hair. Move the Styler over
the sectioned hair starting at the roots about 1/4” away from the scalp. Run
the Styler slowly through to the ends of the hair with light pressure.
STEP3: Repeat this process, section by section until your hair is
completely straight, soft and smooth.
CURLING YOUR HAIR
The steam styler’s rounded edge plates enable you to also create curls and
light waves
STEPI: Prep your hair. make sure your hair is clean & tangle -free.
STEP2: Take a small section of hair, and insert it into your styler. Your
sections can vary in size for depending on the size of curl you are trying to
obtain.
STEP 3: Twist your wrist, (the one holding the styler), about a half-
turn, then pull, and twist again. For a beach wave, keep the ends of your hair
out of the styler. Repeat on entire head.
STEP4 (ALTERNATE): Twist and pull just as Step 3 indicated, but for a
tighter curl, twist the mid-shaft to ends around the entire iron mimicking
what you would do with a curling tron.
TIP: You may want to change the direction of your curls near you face
based on personal preference.
| SUGGESTED STYLER TEMPERATERE SETTING | HAIR TYPE |
|---|---|
| LOW 150° C = 304°F | Fragile, very fine textured hair |
| Medium 190°T – 374°F | Normal, medium textured Hair |
| High 235°C =450°F | Thick resistance, coarse textured Hair |
CLEANING AND MAINTENANCE
Ensure the unit is unplugged and cool. To maintain the effectiveness of your product, wipe clean after use with a damp cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
SERVICE AND WARRANTY
This product has been checked and is free of defects. We warrant this product
against any defects that are due to faulty material or workmanship for the
warranty period from the original date of consumer purchase. If the product
should become defective within the warranty period, we will repair any such
defect or elect to replace the product or any part of it without change
provided there is proof of purchase. This does not mean an extension of the
warranty period.
If you find the water tank has a little water that is normal, as our product
is 100% tested with water as part of our quality control procedure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>