WeLLIFE My Unicorn Balance Bike User Manual
- June 17, 2024
- WeLLife
Table of Contents
WeLLIFE My Unicorn Balance Bike
Speed Fire – MyUnicorn
INSTRUCTIONS – Please read these instructions carefully before use and keep them for future reference.
WARNINGS For the safety of your child WARNINGS!
- Check it regularly for signs of wear and damage and make sure the screws and bolts are tightened correctly.
- Should any part be visibly damaged, do not use the toy and keep it out of children’s reach.
- Only use this toy on flat surfaces without obstacles.
- Never use it on sloping surfaces, near motor vehicles, roads, swimming pools, hills, car and lorry entrances, or any other hazardous areas.
- Always check that children’s shoes are fastened properly.
- Make sure this toy is only used by one child at a time.
- Young children should only ride under constant supervision.
- This bicycle is to be assembled by an adult.
- Choking hazard due to small parts.
- Check all parts & fixtures are secure before allowing a child to ride this bike.
- Not for children with a body weight of more than 35 kg.
- This toy must be used with caution as children need a certain level of ability to be able to ride it safely and avoid falls or collisions which can cause injuries to users or other third parties.
- Before allowing children to use the toy, it is recommended to teach them how to use the toy properly.
- WARNING! Protective equipment should be worn.
- Do not leave the toy exposed to environmental elements (rain, direct sunlight, etc.).
- Always dry the metal parts to prevent the formation of rust if the trike has come into contact with water.
- Clean the trike with a damp, soft cloth if needed. Do not submerge the trike in water.
CONTENTS
- Handlebar
- Handlebar cover
- Front fork
- Link tube
- Front-wheel
- Saddle
- Seat pillar
- Saddle clamp
- Rear wheel
- Rear fork
- Closing button
ASSEMBLY
- Press and hold the closing button at A, and move the vehicle Body along the arrow unfold it in the right direction, and it will make a “click” sound when it is unfolded in place.
- Body deployment status
-
Pull out the frame and use the Z-type hex key to remove the front fork protection cover. Remove the screw on the front fork cover and Pull off the front fork protective cover.
-
Pull out the handlebar and rotate the front fork indicated in the figure.
-
Insert the screw into the insert, tighten the screw with a Z-type tool, and complete the assembly.
-
Cover the hole with the appropriate plug.
-
The saddle can be adjusted up and down, and the appropriate position can be selected according to the height of the child.
-
Use the Z-type tool to loosen the screw on the saddle pipe clamp appropriate position, and use the Z-shaped tool to tighten the screws.
- Installation completion status
- Press and hold the folding button to fold the platform Into the state shown in the figure
- Wellife di VP
- Via Marmolada 40
- Bussolengo (Verona)
- Italy
- wellifesport.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>