SEVNNENS SCPD-141435 Solar Energy Music Lawn Lamp Instruction Manual

SEVNNENS SCPD-141435 Solar Energy Music Lawn Lamp

Product function

This product is a solar energy lawn light with music playing function. The product has built-in Bluetooth power amplifier and loudspeaker, which can realize bluetooth sound function; The light source is composed of LED array, and the brightness of light can be changed. The appearance of the product is simple and generous, no need to install wiring, easy to use.

Instructions for use

1. Charging voltage: 5V-1A. There is a charging indicator beside the charging port.
   When it is in the charging state, the indicator is red, and when it is in the charging completion state, the indicator is green.

2. Product switch introduction:

   • ON/OFF switch: This switch is the main light switch. After this switch is turned ON, the product starts to work.
   • Light intensity adjustment switch: The product light intensity can be adjusted by toggle the position of the switch.
   • Bluetooth switch: This switch is the control switch of Bluetooth on and off. When you turn on the Bluetooth switch, there will be a prompt sound, and the blue light on the side will be on. At this time, you can turn on the Bluetooth of the mobile phone, find the available Bluetooth device, connect the Bluetooth device named XFW-M38, and then play the music in the mobile phone through the solar music lawn lamp. The product can play music continuously for up to 3 hours. If intermittent or murmur occurs, usually with insufficient power, connect a charging adapter or wait for solar energy to replenish.

3. Installation and fixing of products: When using the product, pull out the hidden pins of the product, insert the pins into the lawn and adjust the product to the proper angle.

Matters needing attention

1. Turn off Bluetooth when you don’t use it because it is also using up power when you don’t play music.
2. When using solar energy to charge, the product usually needs direct sunlight for 4-6 hours to fully charge. Please ensure sufficient sunshine duration.
3. The product has a built-in photosensitive switch. When you need to test light during the day, you need to cover the solar panel or go to a dark place. At this time, after turning on the on/off switch, the light will automatically light up.

Applicable scenarios

Villas, Courtyards, Gardens, Outdoor trips, etc.

Packing list

Product body, One USB data cable, Product manual.

Technical Parameters

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>