RVZONE RV Door Handle Grab Bar LED 18 Entry Door Handle Instructions
- June 1, 2024
- RVZONE
Table of Contents
RVZONE RV Door Handle Grab Bar LED 18 Entry Door Handle
Product Information
Specifications
- Product Name: RV/Boat LED Grab Handle
- Package Contents: Two half handles, One acrylic LED light with
wire, One VHB 3M tape, Six screws
Product Usage Instructions
- Installation Steps:
- Put the wired end of acrylic LED into the handrail, and thread the wire out from the bottom of the handrail.
- Take 3M VHB tape through the wire and bond it to the handrail installation end.
- Attach the other half of the handrail to the other end of the acrylic LED.
- Ensure the installation position, then tear off the 3M VHB glue, and fix the grab handle with screws.
- Light up the LED grab handle!
FAQ
Q: Can the RV/Boat LED Grab Handle be used in outdoor environments?
A: Yes, the handle is designed for outdoor use and is weather-resistant.
Q: How do I replace the LED light if it stops working?
A: To replace the LED light, carefully detach the handle, disconnect the wires, and replace the LED light module with a new one.
Q: Can I paint over the acrylic LED light?
A: It is not recommended to paint over the acrylic LED light as it may affect its performance and durability.
CONTENTS OF PACKAGE
THE RV/Boat LED Grab Handle packaging should
include the following parts to make the installation simple and convenient.
- Two half handles,
- One acrylic LED light with wire,
- One VHB 3M tape;
- Six screws.
IMPORTANT SAFETY INFORMATION
- Disconnect battery before installing or replacing the RV/Boat LED Grab Handle. RV/Boat LED Grab Handle is designed to be used only with 12 DC Power [Automotive/Boat Type], any modifications of the unit may result in a hazard and will VOID the warranty.
- RV/Boat LED Grab Handle lighting fixture must be installed in accordance with any state and national codes.
- Please do not attempt to open the RV/Boat LED Grab Handle housing as there are no serviceable parts inside and doing so WILL VOID the warranty.
- Please read all of the installation instructions before installing the RV/Boat LED Grab Handle.
INSTALLATION INSTRUCTIONS FOR THE RV/Boat LED Grab Handle
-
Put the wired end of acrylic LED into the handrail, and thread the wire out from the bottom of the handrail;
-
Take 3M VHB tape through the wire and bonded to the handrail installation end;
-
Attach the other half of the handrail to the other end of the acrylic LED;
-
Make sure the installation position, tear off the 3M VHB glue, and fix the grab handle with screws.
- Light it up!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>