ideal lux 8I306995 Perline 2Lt Pendant Light Instruction Manual

ideal lux 8I306995 Perline 2Lt Pendant Light

Product Information

Specifications

• Model: Perline SP2
• Power: G9 max 2 x 40W
• Voltage: 220-240V, 50/60Hz
• Color Options: NERO, OTTONE
• Product Code: 8021696306995 (NERO), 8021696282107 (OTTONE)

Product Usage Instructions

1. Make sure to follow the assembly instructions by reading the numerical progression provided in the manual.
2. The installation of this lighting fitting should be carried out by a qualified electrician.
3. Ensure the power is switched off before starting the installation.
4. Use suitable screws and plugs for mounting the product securely.
5. If the lamp does not turn on, check and replace the fuse if necessary.

Important Safety Instructions

• The installation must be completed by a qualified electrician.
• Always disconnect the power supply before any installation or maintenance work.
• Avoid looking directly at the light source to prevent eye damage.
• Do not attempt to replace the LED light source unless specified for end-user replacement.

Contact Information

• Manufacturer: IDEAL LUX srl Address: Via Taglio Destro 32, 30035 Mirano (VE), Italy Website: www.ideal-lux.com

FAQ

• Q: Can I replace the light source myself?
• A: Depending on the energy efficiency class, some light sources can be replaced by end-users, while others require authorized personnel.
• Q: What should I do if the lamp does not turn on?
• A: Check and replace the fuse if necessary. If the issue persists, contact the manufacturer or a qualified electrician.
• Q: Is it safe to install the product without professional help?
• A: The manual recommends that the installation be done by a qualified electrician to ensure safety and proper setup.

THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.

• Suspension lamp Suspension
• G9 max 2 x 40W / 220~240V 50/60Hz
  • 8021696306995 NERO
  • 8021696282107 OTTONE

Dimensions

Features

Installation Instructions

• This product is provided with a light source with effificiency energy class of:

Energy Effificiency Class

• 8021696209043 F

ICONE

• Replaceable light source by an end-user.
• Replaceable LED light source by an end-user.
• Replaceable light source by authorized personnel only.
• Non-replaceable light source. Upon the end of the life of the light source, the whole product will be replaced.
• Replaceable control gear by an end-user.
• Replaceable light source by authorized personnel only.
• Upon the end of the life of the control gear, the whole product will be replaced.

SAFETY INSTRUCTIONS

1. This fitting is produced and tested under the strictest European safety standards (EN 60.598-1).
2. This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
3. As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
4. If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician.
5. Always isolate power before commencing installation, maintenance or repair.
6. The luminaire contains certain parts which can be very hot.
7. Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
8. Always tighten the screws firmly to avoid contact problems.
9. This fitting should only be installed indoors.
10. Luminaires not suitable for recessed on normally flammable surfaces.
11. Luminaire not suitable for direct mounting on normal flammable surfaces.
12. This fitting is only suitable for fixing the ceiling.
13. This fitting is only suitable for fixing the wall.
14. The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
15. Only use lamps that do not exceed the maximum specified wattage.
16. Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
17. Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing them.
18. Cracked or broken safety glass has to be replaced immediately. Use only manufacturer approved parts complying with regulations.
19. Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
20. This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
21. Class I Electrical safety is guaranteed by the main insulation and an additional protective conduc- tor (earthing) connected with the metal frame of the lamp. Earthing is obligatory.
22. Class IL electrical safety is guaranteed by the main insulation and double or reinforced insulation. Earthing is not necessary.
23. Class Ill Electrical safety is guaranteed by the very low power supply (less than 50 Volt). Earthing excluded.
24. Not protected.
25. Protected against solid objects greater than 50 mm.
26. Protected against solid objects greater than 12 mm.
27. Protected against solid objects greater than 2,5 mm.
28. Protected against solid objects greater than 1mm.
29. Dust protected.
30. Totally protected against dust infiltration.
31. Not protected.
32. Protected against vertically falling water drops.
33. Protected against water drops falling with a maximum angle of 15° to the vertical axis.
34. Protected against rain.
35. Protected against splashing water.
36. Protected against water jets.
37. Protected against strong water jets.
38. Protected against temporary immersion.
39. Protected against prolonged immersion.
40. Luminaire not suitable for covering with thermally insulating material.
41. Caution, risk of electric shock.
42. Do not stare at the operating light source.

CONTACT

• IDEAL LUX s.r.l.
• Via Taglio Destro 32
• 30035 Mirano (VE) Italy
• www.ideal-lux.com.

References

• The domain name Electrician.LA is for sale

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>