ideal lux SP12 Leaves Pendant 12Lt Light Instruction Manual

ideal lux SP12 Leaves Pendant 12Lt Light

Product Specifications

• Brand: Ideal Lux
• Model: Leaves SP12
• Maximum Wattage: G9 max 12 x 40W
• Voltage: 220-240V
• Frequency: 50/60Hz
• Colour: BIANCO
• Energy Efficiency Class: F

Product Usage Instructions

Installation:

1. Ensure that the installation is carried out by a qualified electrician.
2. Follow the assembly instructions provided in numerical order.
3. Refer to the user manual for detailed installation steps.

Replacing Light Source:

This product is equipped with a replaceable light source. Follow these steps to replace the light source:

1. If the light source is replaceable by an end-user, carefully remove the old light source and insert a new one of the same type.
2. If replacement is only to be done by authorized personnel, contact a qualified technician for assistance.

Safety Instructions:

Follow these safety guidelines while using the product:

1. Always disconnect the power supply before installation or maintenance.
2. Avoid looking directly at the light source.
3. Use appropriate fixtures and accessories for installation as per regulations.
4. In case of damaged external cables, replace them only with parts approved by the manufacturer or a qualified electrician.
5. Do not disassemble the product with non-replaceable LED light sources.
6. If the lamp fails to turn on, check and replace the fuse if necessary.

Frequently Asked Questions

• Q: Can I replace the LED light source myself?
  • A: Depending on the type of light source, it may be replaceable by the end-user or may require replacement by authorized personnel. Refer to the user manual for specific instructions.
• Q: What should I do if the lamp does not turn on?
  • A: Check the fuse and replace it if necessary. If the issue persists, contact customer support for further assistance.
• Q: Is it safe to install the product without professional help?
  • A: For safety reasons, it is recommended to have the product installed by a qualified electrician to ensure proper installation and functionality.

What’s Include

Dimension

Features

Installation Instruction

This product is provided with a light source with effificiency energy class of:

Energy Efficiency Class

• F

LEGENDLEGENDAA ICONE ICONE

• Replaceable light source by an end-user.
• Replaceable LED light source by an end-user.
• Replaceable light source by authorized personnel only.
• Upon end of life of the light source, the whole product will be replaced.
• Replaceable control gear by an end-user.
• Replaceable light source by authorized personnel only.
• Upon end of life of the control gear, the whole product will be replaced.

SAFETY INSTRUCTIONS

1. This fitting is produced and tested in accordance with the strictest European safety standards (EN 60.598-1).
2. This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
3. As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
4. If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician.
5. Always isolate power before commencing installation, maintenance or repair.
6. The luminaire contains certain parts which can be very hot.
7. Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
8. Always tighten the screws firmly to avoid contact problems.
9. This fitting should only be installed indoors.
10. Luminaires not suitable for recessed on normally flammable surfaces.
11. Luminaire not suitable for direct mounting on normal flammable surfaces.
12. This fitting is only suitable for fixing to the ceiling.
13. This fitting is only suitable for fixing to the wall.
14. The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
15. Only use lamps which do not exceed the maximum specified wattage.
16. Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
17. Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing.
18. Cracked or broken safety glass has to be replaced immediately. Use only manufcturer approved parts complying with regulations.
19. Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
20. This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
21. Class I Electrical safety guaranteed by the main insulation and an additional protective conduc- tor (earthing) connected with the metal frame of the lamp. Earthing is obligatory.
22. Class I| Electrical safety guaranteed by the main insulation and a double or reinforced insulation. Earthing not necessary.
23. Class III Electrical safety is guaranteed by very low power supply (less than 50 Volt). Earthing excluded.
24. Not protected.
25. Protected against solid objects greater than 50 mm.
26. Protected against solid objects greater than 12 mm.
27. Protected against solid objects greater than 2,5 mm.
28. Protected against solid objects greater than 1mm.
29. Dust protected.
30. Totally protected against dust infiltration.
31. Not protected.
32. Protected against vertically falling water drops.
33. Protected against water drops falling with a maximum angle of 15° to the vertical axis.
34. Protected against rain.
35. Protected against splashing water.
36. Protected against water jets.
37. Protected against strong water jets.
38. Protected against temporary immersion.
39. Protected against prolonged immersion.
40. Luminaire not suitable for covering with thermally insulating material.
41. Caution, risk of electric shock.
42. Do not stare at the operating light source.

IDEAL LUX s.r.l.

• Via Taglio Destro 32
• 30035 Mirano (VE) Italy
• www.ideal-lux.com

IDEAL LUX Warehouse

• Via delle Industrie, 8/D
• 30036 Santa Maria di Sala (Venezia)
• 8.00 – 12.00 / 13.30 – 17.00

References

• The domain name Electrician.LA is for sale

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>