ArmstrongFlooring Scotia 15mm Wild Wood Tawny Instruction Manual

Table of Contents

ArmstrongFlooring-Scotia-15mm-Wild-Wood-Tawny-PRODUCT

Specifications
- Scotia: 15mm
- Endcap: 40mm
- T.Mould: 45mm
- Stair nosing: 114mm

Step 1: Remove Underlay
- Remove underlay from the risers and treads before installing the trims and accessories.
Step 2: Cut Riser
- Cut the riser to finish flush with the tread height for a professional finish.
Step 3: Measure and Cut Treads
- Measure and cut the treads to finish flush with the risers for a seamless look.

Q: What is the purpose of Scotia, Endcap, T.Mould, and Stairnosing?
- A: Scotia is used for XYZ, Endcap is for ABC, T.Mould serves DEF, and Stairnosing is essential for GHI.
Q: Can these trims and accessories be used on all types of flooring?
- A: These trims and accessories are designed to be compatible with most flooring types, but it’s recommended to check compatibility with your specific flooring material.
Q: How should I clean and maintain these trims and accessories?
- A: To clean, use a mild detergent and a damp cloth. Avoid harsh chemicals that may damage the finish. Regular maintenance with gentle cleaning is recommended to preserve the appearance of the trims and accessories.

Flooring Trims & Accessories

Scotia 15mm
To cover expansion gaps at walls/vertical surfaces.

Leave 10mm expansion (as per installation guides).
Install after the floor is laid. Use a multi-tool to ensure the correct expansion gap if required.
Pin/Brad/Glue to a wall or vertical surface at A, not to flooring.
Can also be used with Laminate Flooring

Endcap 40mm
To cover expansion gaps at junctions with carpet/doorways and adjacent to external doorways like sliding aluminium doors.

Leave 10mm expansion (as per installation guides).
Install after the floor is laid. Use a multi-tool to ensure the correct expansion gap if required.
Glue to subfloor with non-foaming polyurethane adhesive at A
Hold in place with painter’s tape (and weights where required) for 24 hours – no foot traffic whilst the adhesive cures.

T.Mould 45mm
To cover expansion gaps at doorways.

Leave 10mm expansion (as per installation guides).
Install after the floor is laid. Use a multi-tool to ensure the correct expansion gap if required.
Glue to subfloor with non-foaming polyurethane adhesive at A
Hold in place with painters’ tape (and weights where required) for 24 hours – no foot traffic whilst the adhesive cures.

Stair nosing 114mm

To professionally finish stairs.

Step 1: Remove underlay from risers and treads.
Step 2: Cut the riser to finish flush with tread height.
Step 3: Measure and cut trends to finish flush with the Stairnosing, with the tread lock tray under the Stairnosing edge at C.
Step 3: Use non-foaming polyurethane adhesive (full coverage) to adhere the riser and tread to the staircase.
Step 4: Use non-foaming polyurethane adhesive (full coverage) to adhere the stair nosing on both A and B surfaces.
Step 5: Hold in place with painters’ tape (and weights where required) for 24 hours – no foot traffic whilst the adhesive cures.
Step 6: As the stairs are now fully glued, they can be finished at edges/junctions with a matching caulking compound.