ideal lux Spike PL1 Round Ceiling Light Instruction Manual

: June 1, 2024
: ideal lux

Table of Contents

ideal lux Spike PL1 Round Ceiling Light
IDEALUS
SAFETY INSTRUCTIONS
Product Specifications:
FAQ:
- Q: Can the LED light source be replaced by the user?
- Q: What should I do if the external power cable is damaged?
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ideal lux Spike PL1 Round Ceiling Light

INSTRUCTION MANUAL

Model: GX53 max 1 x 15W / 220~240V, 50/60Hz
– 8021696277417 BIANCO,
– 8021696310886 CROMO,
– 8021696278704 NERO,
– 8021696314303 NICKEL,
– 8021696285238 OTTONE,
– 8021696310893 RAME,

Ceiling Light

FOLLOW THE ASSEMBLY INSTRUCTIONS BY READING THE NUMERICAL PROGRESSION

FOLLOW THE ASSEMBLY INSTRUCTIONS BY READING THE NUMERICAL
PROGRESSION

THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.

This product is provided with a light source with effificiency energy class of:

Energy Effificiency Class

| Replaceable light source by an end-user.
---|---
| Replaceable LED light source by an end-user.
| Replaceable light source y authorized personnel only.
| Non-replaceable light source. Upon end of life of the light source, the whole product will be replaced.
| Replaceable control gear by an end-user.
| Replaceable light source by authorized personnel only.
| Upon end of life of the control gear, the whole product will be replaced.

IDEALUS

SAFETY INSTRUCTIONS

1. This fitting is produced and tested in accordance with the strictest European safety standards (EN 60 .598-1).
2. This fitting cannot be disposed of as household waste. For disposal information ask the loca author l ities about how to co llect it.
3. As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
4. If the external wire is damaged it has to be replaced exclusively b? the manufacturer, distributor or by a qualified electrician.
5. Always isolate power before commencing installation, maintenance or repair.
6. The luminaire contains certain parts which can be very hot.
7. Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
8. Always tighten the screws firmly to avoi d contact problems.
9. This fitting should only be installed indoors.
10. Luminaires not suitable for recessed on normall y flammable surfaces.
11. Luminaire not suitable for direct mounting on normal flammable surfaces.
12. This fitting is only suitable for fixing to the ceiling.
13. This fitting is only suitable for fixing to the wall.
14. The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
15. Only use lamps which do not exceed the maximum specified wattage.

16.Jways observe the minimum distance between the lamp arid the surface bein g lit, as shown in the Icon. The lamp can cause a fire ff the minimum distance is not observed.
17. Auto-protected bulb . Only use bulb s marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before repla cing.
18. Cracked or broken safety glass has to b e replaced Immediately. Use only m an ufcturer approved parts complying with regulations.
19. Light source with not-su bstitutable light emittin g diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wip e with a damp cloth . Do not use solvents or strong detergents.
20. This fitting Is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
21. Class I Electrical safety guaranteed by the main in sulation arid an additional protective conductor (earthing) connected with the meta l fr am e of the lamp. Earthing Is obligatory.
22. Class II Electrical safety guaranteed by the main Insulation and a double or r einforced Insulation.

Ear thing not necessary.

23. Class Ill Electri cal safety guaranteed by very low power supply (less than 50 Volt). Earthing excluded.
24. Not protected.
26. Pro tected against solid objects greater than 50 mm.
26. Protected against solid objects greater than 12 mm.
27. Protected against solid objects greater than 2,5 mm.
28. Protected against solid objects greater than 1 mm.
29. Dust protected.
30. Totally protected against dust Infiltration.
31. Not protected.
32. Pro tected against vertically falling water drops.
33. Protected against water drops falling with a maximum angle of 15° to the vertical axis.
34. Protected against rai n.
35. Protected against s plashing water.
36. Protected against water jets.
3 7 . Protected against strong water jets.
38. Protected against temporary Immersion.
39. Protected against prolonged Immer sion.
40. Luminalre not suitable for covering with thermally Insulati ng material.
41. Caution, risk of electric shock.
42. D o not stare a t the operating light sour ce.