dunimed KL4204 Shower Stool with Backrest Instruction Manual
- June 1, 2024
- dunimed
Table of Contents
Assembly instructions
Shower stool with
backrest
KL4204 Shower Stool with Backrest
Parts:
- Seat (A)
- Underframe with U-shaped centre (B)
- Underframe with spherical centre (C)
- 2x frame backrest (D)
- Backrest (E)
- 4x adjustable leg (F)
- 4x screws 58mm (G)
- 5x screws 38mm (H)
- 9x rings (I)
Step 1: Mounting the underframe
Place seat (A) bottom up on the floor. Place underframe with U-shaped
centre (B) at an angle to the seat in the recess provided for that purpose
recess. Then place the underframe with spherical centre (C) crosswise over the
first underframe (B). As both bases contain a notch, the frames fit together
neatly. Then first attach 1 screw 38 mm (H) with ring (I) in the centre.
Step 2: Frame back support
Place everything you assembled in step 1 on a table or chair. Then place
both backrest frames (D) on top of the base so that the holes in which the
screws are to be fastened overlap. Then attach 4 screws 58mm (G) with rings
(I) in the holes provided.
Step 3: Mounting the legs
Place backrest (E) and fasten it with 4 screws 38mm (H) and rings (I). Then
place the 4 adjustable legs (F) on the frames. Pass the silver pin through the
desired hole so that you reach the correct height. It is important that each
pin is at the same height with all 4 legs.
Step 4: Completion
When the 4 legs are fixed at the correct height, the Dunimed shower stool
is ready for use.
Podobrace B.V.
Marconistraat 9
1131JW Volendam Netherlands
info@podobrace.nl
Made in China
Tel: +31 85-2010818
www.podobrace.com