ideal lux Audi-80 SP5 Suspension Lamp Instruction Manual
- June 1, 2024
- ideal lux
Table of Contents
**ideal lux Audi-80 SP5 Suspension Lamp Instruction Manual
**
Product Using Instruction
THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFE
Suspension lamp
Suspension  
G9 max 5 x 40W / 220~240V 50/60Hz
– 8021696197661 FUMÈ
– 8021696031743 TRASPARENTE  
 
  

 This product is provided with a
light source with efficiency energy class of:
This product is provided with a
light source with efficiency energy class of:
Energy Efficiency Class
LEGENDA ICONE
- 
Replaceable light source by an end-user. 
  
- 
finale. Replaceable LED light source by an end-user. 
  
- 
Replaceable light source by authorized personnel only. 
  
- 
Non-replaceable light source. Upon end of life of the light source, the whole product will be replaced. 
  
- 
Replaceable control gear by an end-user. 
  
- 
Replaceable light source by authorized personnel only. 
  
- 
Upon end of life of the control gear, the whole product will be replaced. 
  
SAFETY INSTRUCTIONS
- 
This fitting is produced and tested in accordance with the strictest European safety standards (EN 60.598-1). 
  
- 
This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it. 
  
- 
As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician. 
  
- 
If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician. 
- 
Always isolate power before commencing installation, maintenance or repair. 
  
- 
The luminaire contains certain parts which can be very hot. 
  
- 
Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable. 
  
- 
Always tighten the screws firmly to avoid contact problems. 
  
- 
This fitting should only be installed indoors. 
  
- 
Luminaires not suitable for recessed on normally flammable surfaces. 
  
- 
Luminaire not suitable for direct mounting on normal flammable surfaces. 
  
- 
This fitting is only suitable for fixing to the ceiling. 
  
- 
This fitting is only suitable for fixing to the wall. 
  
- 
The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain. 
- 
Only use lamps which do not exceed the maximum specified wattage. 
  
- 
Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed. 
  
- 
Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing. 
  
- 
Cracked or broken safety glass has to be replaced immediately. Use only manufacturer approved parts complying with regulations. 
- 
Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents. 
- 
This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse. 
- 
Class | Electrical safety guaranteed by the main insulation and an additional protective conduct- tor (earthing) connected with the metal frame of the lamp. Earthing is obligatory. 
- 
Class II Electrical safety guaranteed by the main insulation and a double or reinforced insulation. Earthing not necessary. 
- 
Class III Electrical safety guaranteed by very low power supply (less than 50 Volt). Earthing excluded. 
- 
Not protected. 
  
- 
Protected against solid objects greater than 50 mm. 
- 
Protected against solid objects greater than 12 mm. 
  
- 
Protected against solid objects greater than 2,5 mm. 
  
- 
Protected against solid objects greater than 1mm. 
  
- 
Dust protected. 
  
- 
Totally protected against dust infiltration. 
- 
Not protected. 
- 
Protected against vertically falling water drops. 
  
- 
Protected against water drops falling with a maximum angle of 15° to the vertical axis. 
  
- 
Protected against rain. 
  
- 
Protected against splashing water. 
  
- 
Protected against water jets. 
  
- 
Protected against strong water jets. 
  
- 
Protected against temporary immersion. 
- 
Protected against prolonged immersion. 
- 
Luminaire not suitable for covering with thermally insulating material. 
- 
- 
Caution, risk of electric shock. 
- 
Do not stare at the operating light source. 

References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>
 
 









