PSAZ-1000P 1000W Platinum Power Supply User Manual
- June 2, 2024
- PSAZ
Table of Contents
PSAZ-1000P 1000W Platinum Power Supply
Features
- Complies with ATX12V V3.1
- Efficiency ≧ 92% typical load
- Eco semi-fanless fan control switch
- 120mm smart hydraulic bearing (HYB) fan
- LLC Full Bridge Topology with DC-DC module design
- Japanese electrolytic capacitors
- Support PCIe Gen 5.1 graphics card
- High-quality native 16-pin cable supports 600W output
- Complete protection: OCP/OVP/OPP/SCP/OTP/UVP
- 80 PLUS® PLATINUM certified
- Fully modular design
Specifications
| PSAZ-1 0 0 0 P | 1000W PLATINUM |
|---|---|
| **** AC Input | 100-240VAC, 12-6A, 50-60Hz |
| **** DC Ouput Voltage | +12V |
Max Ouput Voltage
| 83A| 20A| 20A| 0.3A| 3A
Combined Power| 996W| 120W| 3.6W| 15W
Total Power| **** 1000W
Dimensions
Smart Fan Control
- Fan voltage varies with the ambient temperature and or output power.(when Switch ON)
- Zero RPM mode (when Switch OFF)
Zero RPM mode allows the fan to remain off during low to medium loads. This technology uses various temperatures from inside the PSU and the power output level to determine when active cooling is needed for the PSU.
When you’re pushing it hard the fan will turn itself on to ensure that it gets the cooling it needs without any extra noise.
Detachable Connectors
Connectors
Connectivity and Cable Lengths
- ATX/MB 20+4Pin x 1 : 610mmx1
- CPU/EPS 4+4 Pin x 2 : 650mmx2
- PCI-e 5.0 16 Pin x 1:720mmx1
- PCI-e 6+2 Pin x 4 : 600mmx4
- SATA x 12:450mm+150mm+150mm+150mmx3
- Molex x4:450mm+150mm+150mm+150mmx1
12VHPWR Cable Guide
The 12VHPWR connector and the terminals used in it are much smaller than the
previous generation. Through our extensive testing, it appears that bending
the wires too close to the connector could result in some of the terminals
coming loose or misaligning within the connector itself.
This may lead to an uneven load across the other wires, increasing the risk of
overheating damage.
The risk of this is substantially higher if the bend is done horizontally in
relation to the connector orientation (left to right).
Leave enough 12VHPWR cable length (around 35mm), then do cable management.
The connectors should click to lock in. Bend starting at 35mm from
connector
RTX 40 Series is bigger than the rest of the models therefore make sure that
the width of the case is wide enough for the PSU and RTX40 Series GPU.
Once complete install the system, please DO NOT PUSH THE SIDE PANEL otherwise
the cable will be squeezed and there will be the risk of OVERHEATING &
BURNING.