Vitura V3-171017 Corner Whirlpool Bath Installation Guide
- June 2, 2024
- Vitura
Table of Contents
Quality Acrylic Baths
Manufactured in the UK
Corner Bath
Installation Instructions
V3-171017 Corner Whirlpool Bath
– Read through the instruction booklet first before commencing any work.
If you are unsure of any aspect of the installation, we recommend you contact
a reputable tradesperson.
– Prior to fitting your bath, carefully remove all the packaging and film from
the bath and examine the bath for damage and suitability of colour match.
– Check the panel fit and match prior to installation.
– Any refixing costs or claims for wrong colour match and/or any other fault
will not be accepted after fixing.
No claims for the above will be accepted once the bath is fitted.
25 Year
Guarantee
Before you start
– Before fixing remove ALL protective covering and examine carefully. The
polythene film must be removed in full and the bath checked for any visible
damage.
– Unpack and check the product is complete and undamaged.
– Have the correct tools available.
– Please notify the retailer immediately of any damage or faults. The
manufacturer cannot be held responsible for any installation costs that may
arise from damaged or faulty product being installed. The guarantee does not
cover impact related damage. Please dispose of all packaging with due regard
to the environment.
Safety
– Handle the bath with care.
– This product is heavy and requires two persons to carry.
– When drilling walls, check first for hidden pipes and cables.
– Use safety eyewear when drilling.
– Keep small parts away from children.
Tools required
Ensure drill bit used is suitable for wall surface!
Tools shown not supplied
Parts provided
– We
have taken great care to ensure that this product reaches you in perfect
condition. However should any parts be damaged or missing please contact your
point of purchase. This does not affect your statutory rights. In addition if
you require replacement parts your point of purchase will be happy to assist.
– You may have additional spare parts, please discard with due regard to the
environment. 
Please Note:
– Baths should be set at supplied panel height.
– The baseboard is encapsulated into the bath.
– Half the panel clips supplied should be secured (if possible) to the floor.
– Before the final fixing of the bath, fit tap and waste fittings using a suitable
sealing compound. When complete place the bath into position, re-check levels
and make any final adjustments necessary. Finally secure the feet to the floor
and the wall brackets to the wall. Movement may occur if not fitted correctly.
– CHECK THAT THE BATH RIM IS LEVEL.
V3/171017
1002
68/50
Version 2
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>