APEXFORGE V1 Portable Tripod User Manual
- May 15, 2024
- APEXFORGE
Table of Contents
APEXFORGE V1 Portable Tripod
Tripod Introduction
Panning, pitching and 90-degree shooting opera-tion (Fig.2)
- Rotating the horizontal locking knob counter-clockwise to loosen for smooth consistent panning,rotating oppositely to tight it.
- Rotating the handlebar counter-clockwise to loosen for smooth consistent tilting, Rotating oppositely to tight the tilt knob.
- Rotating the vertical flip knob counter-clockwise to adjust the angle of the loading plate, flip up to 90 degree. Rotating oppositely to tight it.
Raising and Lowering the Center Column. (Fig.3)
To raise or lower the center column, turn the center locking knob counter- clockwise and set the column to the desired position. While holding the column in position, turn the column locking knob clockwise to secure the column in place. Don’t over tighten the center column lock, as this could damage the threads.
Extend and fold the leg. (Fig 4,5)
Each Leg section can be adjusted to the desired length by opening the Flip Lock Lever so the Leg is free to slide in or out. Once the desired length is achieved, snap the Flip Lock Lever closed, so that the Leg Section is securely locked. Repeat this step for each Leg and each Section until the Tripod is set to the desired height.
Warnings
- Do not exceed the tripod’s maximum load capacity
- Ensure the ball head is locked
- Do not operate this tripod when the temperature is below -20°C or above 70°C. It is not recommended to operate in saltwater.
- Do not put this tripod in sunlight or lean against the glass of car for a long time
- Do not leave this tripod unattended in public place; please be careful when use it in a dangerous place.
- Remove the camera from the ball head during setup or transport.
- It is not necessary to equip lubricant, Please use standard lubricant or grease when necessary.
- For your safety, keep it out of power supply.
Warranty
Your Warranty Includes
30 Days Refund Guaranty
Within the first 30 days of your purchase, you are allowed to return your
product for a full refund.
30 Days to 3 Months
We will replace the defective unit due to manufacture fault with a new one.
3 Months to 24 Months
Within 24 months, we will provide timely and effective online after-sales
service after your purchase.
How to Return Your APEXFORGE Products
- Contact support@apex-forge with your order number.
- We will issue you the RMA# and return address for your return.
- Please fill out the RMA info, tear off this page and leave it inside your return package. We will issue replace/return after receiving your return.
Return Products Details
To get your returns processed as quickly as possible, please fill out this
form and include it in your return package.
- Purchase Name
- Order Number
- Date of Purchase
- Your Email Address
- Where did you buy it
- If your product is purchased from the Amazon Fulfilled channel, please contact Amazon for a return within 30 days of purchase.
Specifications
- Model: V1
- Material: Aluminum alloy
- Maximum Load Capacity: 5kg
- Maximum Height: 150cm
- Minimum Height: 50cm
FAQ
Q: Can I use this tripod with a heavy DSLR camera?
A: The tripod has a maximum load capacity of 5kg, so it should be suitable
for most DSLR cameras.
Q: How do I clean and maintain the tripod?
A: Use a damp cloth to clean the tripod if necessary. Avoid using
lubricants unless specified. Regularly check for any loose parts and tighten
them as needed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>