Aain w89712 Harmonic Balancer Puller Kit Instruction Manual
- May 15, 2024
- AAIN
Table of Contents
Aain w89712 Harmonic Balancer Puller Kit
REMOVING STEPS
Note: Apply oil to the forcing screw prior to use.
Steps to remove the crankshaft bolt and the crankshaft damper.
- Place a holding device into the slots on the crankshaft damper. See Image 2.
- Place the correct socket and 1/2 in. breaker bar on the crankshaft bolt. Hold the crankshaft damper and turn the crankshaft bolt counter clockwise to loosen the bolt. Crankshaft damper.
- Determine which insert will work best to remove crankshaft pulley. Install the appropriate insert into the end of the forcing screw and then into the crankshaft. See Image 1.
- Attach the 3-jaw puller to the damper and line up the forcing screw with the insert. See Image 2.
- Tighten the forcing screw onto the puller to push against the insert
- Remove the crankshaft damper.
WARNING! Wear eye protection that meets ANSI Z87.1 and OSHA standards.
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>