REINMOSON RMS-WP-TAP-01 Faucet Water Filter for Sink Owner’s Manual

REINMOSON RMS-WP-TAP-01 Faucet Water Filter for Sink Owner’s Manual

RMS-WP-TAP-01
Activated Carbon Filber Faucet Filtration System

About the System

Thanks for choosing REINMOSON Activated Carbon Fiber Faucet Filtration System! This faucet filtration system ensures to give you clean and healthy water with Activated Carbon Fiber (ACF) filter. As to adsorption, ACF has been proven to be 10 to 12 times better than ordinary carbon. It will effectively filter chlorine, unpleasant taste and odor while retaining beneficial minerals in water. The system will meet your needs of clean water with a 320 gallons’ service life, three times longer than other brands.

  Tested and Certified by NSF International in Model RMS-WP-TAP-01 against NSF/ANSI Standard 42 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (0.25% lead).

Performance Data Sheet

System Specifications

NOTE:
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Assembly List

Installation Instructions

How to Use

After installation, open faucet. Switch the Lever (H) to “tap” position, and unfiltered water will run through.
Switch the Lever (H) to its “pure” position, and filtered water will run through.

NOTE:

1. Before first use, run cold water for 1 minute in “pure” position. Do not run hot water above 122°F / 50 °C through the filter. During flush, it is normal to see cloudy water and hear the sound of water pushing air out of the filter cartridge.
2. Check for leaks. If there is any leak, please refer to FAQ.
3. Please switch the lever slowly to avoid damage to mounting base.

Filter Cartridge Replacement

For optimum performance, it is highly recommended you use genuine REINMOSON faucet replacement water filter. And it is also advisable to change your filter every 3 months or 320 gallons to keep water fresh, whichever comes first will vary based on water usage and water quality.

Filter Life Reminder Light

The blue light indicates that the filter is functioning properly, while the red light indicates that it’s time to replace the filter as it has reached its expiration.

Warnings

1. Do not use with water above 122 °F / 50 °c.
2. Flush the system for 1 minute before use after a long time of non-use.
3. Prior to each use, run water through the filter for 5 to 10 seconds to activate the filter.
4. The filter system must be protected against freezing temperatures, frost, snow, sleet, and ice. Exposure to these elements can produce cracks and product failures.
5. Please do not touch the filtered water outlet to prevent bacterial growth.
6. Do not use steel wire brush or corrosive liquids to clean the product.
7. Change the filter every 3 months or 320 gallons for best filtration performance.

FAQ

1.Q: Why does water leak between the mounting base and the faucet?
A:

Leakage in the middle may be due to a clogged filter.
Remove the filter, clean it thoroughly with a clean cloth, and then reinstall it.

2. Q: Why does the filtered water run quite slowly?
A: The filter cartridge may be clogged. Replace the filter cartridge.

3. Q: Why does the unfiltered water run quite slowly?
A: There may be dirt in filter steel mesh. Clean the filter steel mesh.

4. Q: Why does the water taste funny?
A: The filter cartridge is not installed appropriately, or it should be replaced. Please re-install it in a correct way. If there is still bad taste, please replace it.

Receive Your 5 Years Warranty

We offers a 5-year warranty for you.
You are available to contact us with the following methods: WhatApp: +8613922382041
Outlook: REINMOSON@OUTLOOK.COM

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>