ON THE ROCKS 221-0257 Manual Curves User Manual
- May 15, 2024
- ON THE ROCKS
Table of Contents
**ON THE ROCKS 221-0257 Manual Curves User Manual
**
INSTALLATION INSTRUCTION
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS.
Read the operating instructions carefully before putting the appliance into
operation and keep the instructions, the receipt and, if possible, the box
with the internal packing. If you give this device to other people, please
also pass on the operating instructions.
USER MANUAL SYMBOLS
Important information for your safety is specially marked. It is essential to
comply with these instructions in order to avoid accidents and prevent damage
to the machine:
WARNING: This sign warns you of dangers to your health and indicates
possible injury risks.
CAUTION: This sign refers to possible hazards to the machine or other
objects.
NOTE: This sign highlights tips and information
SAFETY INSTRUCTIONS
-
The appliance is designed exclusively for private, domestic use and for the envisaged purpose. This appliance is not suitable for commercial use.
-
Do not use the appliance to cool food or beverages.
-
Do not use the appliance outdoors.
-
Check that the voltage indicated on the appliance rating label corresponds to the voltage in the mains.
-
The power source must conform to the device standards. If the voltage range is large (other than the rated voltage ± 10%), the ice machine may not function properly. If the specific conditions are met, use the ice machine with a voltage regulator.
-
Always plug the appliance into an outlet that is earthed. Risk of electric shock!
-
Appliance is not intended to operate with an external timer or a separate remote-control system.
-
Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges.
-
WARNING: Do not locate multiple portable socket outlets or portable power supplies at the rear of the appliance.
-
Do not place the appliance on or near a hot gas, electric burner or preheated oven.D
-
It is forbidden to place explosive and flammable materials in the ice machine.
-
Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
-
Do not use ice maker in a place with coal gas or other flammable gas leakage.
-
WARNING : Fill with potable water only. Do not use unsuitable water for making ice.
-
The use of corrosive acid and alkali is prohibited.
-
WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
-
WARNING : When positioning the appliance, ensure the supply cord is not trapped or damaged.
-
WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
-
WARNING : Do not damage the refrigerant circuit.
-
If the appliance is wet, unplug it immediately.
-
When storing the appliance, switch the appliance off and always pull the plug out of the socket (pull the plug itself, not the lead).
-
Do not pull or stretch the power cable.
-
Do not operate the appliance without supervision. If you should leave the workplace, always unplug the appliance.
-
Always unplug the appliance after usage (pull the plug itself, not the lead).
-
Always unplug the appliance before moving it in order to prevent damage to the cooling system.
-
Do not flip the appliance over. If the appliance is accidentally overturned, place it in the correct position and wait 2 hours before plugging it in.
-
Periodically check the cable for damage.
WARNING: Do not operate the appliance with a damaged cord. In order to
avoid the risk of an electric shock, never try to repair the appliance by yourself. Bring it to the authorized service station for repair. Use only the original spare parts. -
Do not let the power cord hanging off the edge of a table or bench, or come into contact with hot surfaces.
-
If the surface is cracked, disconnect the appliance from the power supply to avoid electric shock.
-
Make sure the power cord is easily accessible at all times.
-
To protect against risk of electric shock, do not immerse the cord, plug or unit in water or any other liquid.
-
Keep the appliance and its cord out of the reach of children.
-
Do not let children play with the appliance.
-
In order to ensure your children’s safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.
WARNING: Do not allow children to play with the foil. Danger of suffocation! -
Children are not allowed to use the appliance.
-
Unplug when not in use, when adding / removing accessories and before cleaning.
-
Do not touch the moving parts of the appliance. You should always wait until these parts stop moving.
-
The appliance can be used by people with reduced physical, sensory or mental abilities or lack of experience and knowledge, if they are supervised or instructed on how to use the device safely and understand the risks involved.
PARTS IDENTIFICATION
- Lid with window.
- Cover
- Evaporator
- Ice container
- Ice transfer tray in the container
- Control panel
- Air inlet
- Air outlet
- Power cord
| Warning indicator (full ice bucket)
---|---
| Empty water tank warning light
0| Small ice cube indicator light
| ice cube indicator light
| Ice cube size selection button
| Operation indicator light
| Start /stop
BEFORE FIRST USE
-
Read all the instructions carefully and keep them for future reference.
-
Remove the appliance from its packaging. Keep away from children.
-
Inspect the appliance after unpacking for any visual damage. In case of any damage, do not use the
appliance and contact the shop that you bought it -
Before using the appliance for the first time, check that the voltage shown on the appliance rating label corresponds to the voltage in the mains.
-
Make sure that the appliance only plugs into a properly grounded and properly installed socket.
-
Make sure the ice machine is placed on a flat and stable surface to avoid possible malfunction.
-
The angle of inclination during transport of the device and during its operation must not exceed 45° Do not flip the appliance to avoid malfunction of the compressor or cooling system.
NOTE : In the event of a transfer, wait at least 2 hours before using the appliance. Before using the ice maker for the first time, wait 2 hours from the moment you place it on a flat surface -
Leave an opening of at least 20 cm around all sides of the appliance for adequate ventilation,
-
Do not place hot water in the water tank as it may damage the appliance. Use water at room
temperature or lower. -
Do not use the appliance in an environment with very low temperatures (less than 50C).
HOW TO USE
-
Place the appliance on an even surface at a safe distance away from flammable objects. Keep out of the reach of children..
-
Open the lid of the appliance and remove the ice container.
-
Make sure that the drain plug is in place and secured.
-
Place drinking water into the water tank.
NOTE : Do not place water above the MAX mark. -
Place the ice bucket back to its position and close the lid.
-
Press the “D” button to activate the device and then select the desired ice size: 1
• Press the “button once to start the small size ice making process and the indicator light” will light up.
Press the button again to start the large size ice making process and the will light up. “indicator light -
For the next 5-15 minutes ice forms on the evaporator and the ice transfer tray transports the ice
cubes to the ice container. When the ice container is full of ice, the corresponding indicator light will
illuminate. Remove the ice from the ice container with the spatula. After a while the ice production
process will continue its operation automatically. -
The indicator will light up when the water tank is empty and the appliance will stop producing ice automatically. Remove the ice container and add drinking water to the water tank. Repeat the process of step 6 to start the ice making process from the beginning.
-
When you have the desired amount of ice, stop the ice production process by pressing the button and disconnect the appliance from the power supply.
-
Open the lid and transfer the ice from the ice bucket to the freezer.
NOTE: Ice cubes can be stored in the ice machine for approximately 18 hours (depending on ambient temperature). -
It is recommended to change the water in the ice machine once a week. Empty the water tank if the ice machine is not used for a long time. To empty the water tank, open the drain plug located on the bottom of the appliance by turning it.
NOTE: If the appliance is moved, wait for half an hour before plugging it in.
CLEANING
-
Always unplug the appliance and allow it to cool before cleaning. The unit is easier to clean when slightly warm.
-
Never immerse the housing of appliance into water or place in dishwasher.
-
Do not use any caustic or abrasive detergents.
-
Wipe the outside of the appliance with a damp cloth only. Do not use a wire brush or other abrasive utensils for cleaning.
-
Remove the ice container and clean the inside of the appliance with a soft cloth dampened with water or vinegar. Rinse with a clean cloth and wipe well.
-
Wash the ice container and spatula with warm soapy water, rinse and wipe well.
NOTE :- Do not clean the evaporator.
- Empty the water tank dry it well to store the appliance if it is not to be used for a long time.
STORAGE
- Always unplug the appliance before storing it.
- Always make sure that the appliance is cold, dry and clean before storing.
- Always store the appliance out of the reach of children.
- Always store the appliance in a safe and clean place. For the better protection of the appliance, store it in its original packaging.
DISPOSAL OF APPLIANCE AND ACCESSORIES
This symbol appearing on the product, its accessories or accompanying manuals
indicates that the product and its electronic accessories should not be
disposed of with other household trash. In order to avoid possible harmful
effects on the environment or health due to uncontrolled waste disposal,
please separate these products from other types of waste and recycle them.
Household users should contact either the store where they purchased this
product or their local services for details of where and how they can return
these products for environmentally safe recycling.
TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTIONS |
---|---|---|
0 Indicator light does not turn on, | Power on/off button Is not | |
pressed.correctly. | 1. Check the power cord Is connected2. Check the voltage |
shown on the appliance rating label corresponds to the voltage in the mains3.
Internal components are damaged. Contact a qualified technician for
maintenance.
-indicator is light.| I. Ice container is full of ice.2. Low-temperature protection (temperature is lower than 5t).| 1. Remove the ice from the ice container.2. Move the appliance to a warmer place, where the ambient temperature is higher than 5t.
0 indicator is light.| Water container is empty.| 1. Add drinking water Into
water container, and press–IC “Button.2. water supply system is damaged.
Contact a qualified technician for maintenance.
Indicator and 0 Indicator are both light..| Ice container is not place
correctlyinto its position.| 1. Check whether the Ice container Is placed
correctly into its position or any foreign body stuck the ice making box.2.
Internal components are damaged. Contact a qualified technician for
maintenance.
Ice making performance is not good.| 1. Poor heat dissipation.2. Water
temperature is too high.3. Ambient temperature is too high. a. Refrigerant
leakage.| 1. Leave an opening of 20cm on all sides for adequate ventilation
of the appliance.2. Put water in the water tank temperature from 8 t to 25
t.3. Start the process of making Ice at room temperature.4. The cooling
system is damaged. Contact a qualified technician for maintenance.
Abnormal noise| Fan or pump is damaged.| Contact a qualified technician for
maintenance.
Made In China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>