Jialetong RC-18A Remote Control Toys User Manual
- May 15, 2024
- Jialetong
Table of Contents
Jialetong RC-18A Remote Control Toys
Please read this Manual carefully before use and keep it properly for future use.
Packing list
Battery installation and charging of remote control
car and remote control Connect the battery with the charging cable, then plug the USB charging cable into the USB interface of the computer or a USB charger, and then turn on the power. When the red light is on, it means charging. When the red light is off or the green light is on, it means full.
Battery installation method of remote control
- Open the battery cover of the remote control
- Install 2 1.5V “AA” batteries according to the correct polarity and close the battery cover.
- Pay attention to the position of the battery socket and accurately place it in the battery slot.
- After the battery is inserted, Mere can both sides to threaten polio, her inner the secure the battery.
The function of the remote control
Pull out the steering control wheel outwards, and then install it on the mounting hole on the other side to complete the switch between left and right- hand modes.
Operation method
The position. Put off the mete co toot of the vehicle’s flat surface, turn on
the switch of the remote control, wait until the remote control indicator
light stops flashing, and then move the operating lever to operate.
(Note: when the remote control indicator is flashing, the control lever
can not be operated.)
Basic operation diagram for product use
- Pull the remote control lever backward to move the remote control car forward, and pull forward to move the remote control car backward.
- When the control lever is pulled backward halfway, the remote control car will move forward slowly; when the control lever is pulled backward completely,
- The control car will move forward rapidly.
- Turn clockwise to turn the car right, and turn counterclockwise to turn the car left.
- Automatic demonstration: press the automatic demonstration button to remotely control the car.
- It will automatically demonstrate forward/ backward/turn left/turn right, press to stop Press the key and the automatic demonstration will end.
Maintenance and repair
- If you do not use it for a long time, please take out the battery.
- Wipe the car gently with a wet cloth.
- Do not put the product in high temperature, high humidity and direct sunlight.
- Do not put the product in the water, or the electronic components will be damaged.
Precautions
- Please pay attention to the polarity when installing or replacing the battery
- Non-rechargeable battery can not be charged;
- Charging a rechargeable battery should be supervised by an adult
- Do not use old or new batteries or different types of batteries
- Please pay attention to the signal interference nearby during operation, otherwise, the remote control distance will be affected
- When the remote control car slows down, it means that the car is out of power. Please charge the remote control car according to the above method.
- If the remote control is out of power, the indicator will turn dark or does not light up. Please replace the battery with a new one.
- If you do not use it for a long time, please take out the battery in the remote control turn the power switch of the remote control car to the “OFF” position, and take out the battery of the remote control car.
Warning
The USB cable provided with this product is required for charging, Chargers
from other manufacturers cannot be used for charging, Do not use a charging
head with a current exceeding 40A for charging, Otherwise, we will not be
responsible for any problems
Warm tips
When the car is moving, please do not touch the wheels of the remote control
car by hand, to avoid damage to the car.
- Do not use the product on the road where there is traffic, to avoid any accidents.
- Do not use the product in sump, dirt or sand.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used under the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>