bimiti ZL01 Mobile Lectern Podium Stand Installation Guide
- May 15, 2024
- bimiti
Table of Contents
Installation Steps
Please read this installation manual carefully before installation. Pay attention to the screw size, sort out the accessories and count the quantity before installation.
Packaging List:
x4
A. eccentric lock lever
x4
B. eccentric lock head
x4
C. partition nail
x12
D. M5*50 screw
x16
E. tapping screw
x6
F. M6*30 screw
x2
G. M6*20 screw
x4
H. M6*12 screw
x2
I. 8m m rotating handle
x4
J. wheel
x2
K. Q clamp
x1
L. screw driver
x1 x1
1 base plate 2 left panel
x1 x1
3 right panel 4 back panel
x1 x1
5 baffle 6 laminate
x1 x1
7 desktop board 8 curved pipe
x1 x1
9 partition plate 10 stop strip
x2
11 column square tube
Installation steps:
Step 1: Fix the wheel [ J ] to the back of the base plate [ 1 ] using screws [ E ]
Step 2: Use screws [ D ] to connect the base plate [ 1 ] to the left and right panel [ 2 ] and [ 3 ] respectively
Step 3: Use screws [ F ] to connect the column square tube [ 11 ] to the base plate [ 1 ] and the left and right panel [ 2 ] [ 3 ]
Step 4: Connect the left and right plate [ 1 ] [ 2 ] to the back pane [ 4 ] and baffle plate [ 5 ] using screws [ D ]
Step 5: Screw the eccentric lock lever [ A ] into the laminate, insert the assembled part into the left and right panel, place the eccentric lock head [ B ] into the holes, and tighten them
Step 6: Pass the Q clamp [ K ] through the curved pipe [ 8 ] ,use screws [ H ] to connect [ K ] to the desktop board [ 7 ] , use screws [ G ] to pass through [ 7 ] to fix the stop strip [ 10 ]
Step 7: Insert the assembled part into the square tube of the column square tube [ 11 ] as a whole and fasten it with the rotating handle [ I ] . Insert the partition nail [ C ] into the holes on the left and right panel, place partition plate [ 9 ] on the partition nail
Step 8: The overall installation is completed, please check whether all screws and accessories are tightened