Ekster B V EK4FND Ekster Finder Card User Manual
- June 17, 2024
- Ekster B V
Table of Contents
Ekster Finder Card
User Manual
Charge the card
- Connect the cable to the card for charging, Charge the Card for, at least, 2 hours.
Enable pairing mode
-
Press the button once. The LED is flashing, indicating that the Gard is ready for pairing.
(Remark: The tag will turn OFF if not pair within 10 mins) -
From IOS device, launch Find My.
-
Under “Items”, select Add Item.
-
Select “Other Supported Item”. Your device will now search for “Ekster Finder Card”
-
As soon as you see “Ekster Finder Card” display on your device, follow the on-screen prompts to complete the pairing process. A tone is heard from the Card.
Factory reset
- Press the button 3 times and on the fourth time press and hold the button.
- A tone is heard.
- The Card is in pairing mode until it is paired.
(Remark: The tag will turn OFF if not pair within 10 mins)
Learn more
- Press the button one time.
- Tap “Continue On Website” for more information including any Lost Mode message
from the owner and serial number of the card.
Instructions for disabling
- Press the button 2 times and on the third time press and hold the button.
- The LED shall turn off after a while.
This will stop sharing the location of this card.
FCC statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which an be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
CE Statement
We declare that this device is in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU.
Our product does not contain the AC/DC adapter. You need to purchase an DC
5V/1A adaptor which compliance with the directive 2014/30/EU.
The adapter shall be installed near the equipment and shall be easily
accessible.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>