510 DESIGN 5DS100-0030 Jeanie Accent Chair Instruction Manual
- June 17, 2024
- 510 DESIGN
Table of Contents
510 DESIGN 5DS100-0030 Jeanie Accent Chair
Important safety instructions
- Please read carefully all instructions before assembly.
- For your safety and ease, assembly by two or more adults is recommended.
- Keep instructions for future use.
Pre-assembly
- Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
- Take out all parts and hardware from the box.
Parts List
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. THE SELLER IS NOT LIABLE FOR ANY DAMAGES RESULTING FROM THE ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
Assembly Procedures
- Step 1. Assemble the chair on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
- Take the chair back and legs out of the top of the chair body.
- Attach the chair back (P2) to the chair base (P1) as shown below, alignment and push down the metal bracket to lock it firmly.
- Step 2. Attach the legs (P3) to the bottom of the chair base (P1) as shown below, securely tighten all legs, but do not over-tighten the leg.
- Step 3. Turn the assembled chair to an upright position. Failure to follow these instructions may cause the bolts to misalign during assembly Assembly is complete.
- Leveler adjustment: Levelers are pre-installed on the legs. Adjust as needed to make sure the chair is level.
ADDITIONAL NOTE ABOUT SAFETY:
- BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE.
- THEY SHOULD BE INSPECTED AT LEAST EVERY 3 MONTHS AND RE-TIGHTENED AS NEEDED TO PREVENT DAMAGE OR INJURY AND ENSURE STABILITY.
- Thank vou for vour purchase
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>