Ersa 30S Soldering Iron Instruction Manual
- June 17, 2024
- Ersa
Table of Contents
Soldering irons
30 S / 50 S / 80 S / 150 S
MULTI-TIP 1)
Operating instructions
Before taking the tool into use make sure of the following:
-
Read operating instructions and safety instructions completely.
-
Check that the voltage given on the nameplate is the same as your source at the mains.
Tools with low voltages belong to safety class III. -
Before heating up make sure that the tip is properly in position.
a) Tips heated from outside: clamp screw(s) must be tight (see pic. 1a).
b) Tips heated from inside:
The tip must sit close to the heating element so that no air is entrapped
between the tip and the heating element.
The tip can be easily exchanged by taking it off resp. putting on. When
putting it on lift slightly the springy lever of the fixing clip so that the
tip can be pushed on the shaft of the heater without resistance.
Please take care that the springy element on the shaft is pushed up to the
handle (see pic.1b).
① Externally heated soldering tips
a. Bits heated from outside
Outside heating failure
① Internally heated soldering tips
b. Bits heated from the inside
Internal heating failure
Always insert soldering tip fully
Taking into use for the first time and soldering
-
Connect soldering tool to suitable current source.
Attention!
The tip can be removed when the soldering iron is switched off and without using force.
New tip to be inserted till stopped. -
Do not heat up soldering iron without tip.
-
After use let the soldering iron cool down in the air (do not cool off with water).
-
Deposit the soldering iron only on suitable holder (see pic. 2).
Replacement of the heating element
Exchange of heating elements and tips should only be done by competent
persons.
Important! Use only original parts!
| ② A 18 Ersa MULTI-TIP | ② A 04 Ersa 50 S / 80 S / 150 S |
|---|---|
② Nur / only for / seulement pour Ersa 30 S:
Put down only after mounting the supporting ring!
Warning:
Do not make any repairs or alterations to the soldering tool. Repairs are only to be carried out by Ersa or authorized and qualified service stations. The equipment incorporates parts under current and voltage. Inexpert handling can cause death by shock.
Subject to alteration
• 3BA00086 • 7.8.2023 • Rev. 14 • © by Ersa GmbH
Ersa GmbH • Leonhard-Karl-Str. 24 • 97877 Wertheim/Germany
Tel. +49 (0) 9342/800-0 • Fax -127
• service.tools@kurtzersa.de
• www.ersa.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>