Kelderman G5 RAM 2500 Steering Stabilizer Kit Instruction Manual
- June 17, 2024
- Kelderman
Table of Contents
Instruction Manual
G5 RAM 2500/3500 Steering Stabilizer
Kit Instructions
G5 RAM 2500 Steering Stabilizer Kit
-
Remove the OEM steering stabilizer shock and the mounting hardware on the center of the axle.
-
Remove the factory mounting brackets from the passengers side. Locate the new bracket (part# 18400) and install it so the holes are on the front side of the axle like in the picture below. Use the factory bolts and toque to 55 ft/lbs.
-
Locate the drivers side bracket (part# 18839 and 18397) If fastens to the two factory pinch bolts on the steering arm. It also fastens to the outter tie rod end with the 1/2×3” bolts. Torque these bolts to 55 ft/lbs. Make sure the 1/2” bolt is pointing towards the rear of the truck.
NOTE: Some models of dodge truck have only one bolt on the steering link instead of 2. Use part # 18409 instead of 18839.
-
Locate the steering stabilizer bracket (part# 19393), top spacer (part# 18396) and the side spacer (part# 18399). Use the M10x45 bolts to fasten the center top of the bracket to the axle. (just start all the bolts and tighten after all six bolts are installed) Make sure to use the spacer, (part#18396) between the bracket and axle. The bottom of the bracket fastens to the axle with the factory bolts.
Next if the factory differential cover is being used, use spacer (part# 18399) in between the bracket and diff cover. Use the M8x40 bolts in this spot. If you have an aftermarket diff cover, you should not need the spacer. Once all the bolts are started, tighten the OEM bolts on the bottom of the axle to 35 ft/lbs, the M45 bolts to 55 ft/lbs and the m8 bolts to 30 ft/lbs.
-
Locate the shocks. (Fox part# 985-24-068). Use the 1/2×3” bolts on the outside to fasten the shock to the outter mounts. Next locate the shock strap (part# 18402 and two 1/2×3” bolts. Fasten the shocks to the steering stabilizer bracket. Make sure to put the bolts in top down. Once all the bolts are in place, go back and torque the bolts to 75 ft/lbs.
| ITEM NO. | PART NUMBER | DESCRIPTION | QTY. |
|---|---|---|---|
| 1 | 18389 | (DS) Shock Bracket | 1 |
| 2 | 18393 | Steering Stabilizer Bracket | 1 |
| 3 | 18396 | 3/8″ Spacer | I |
| 4 | 18397 | Axle Mounting Bracket w/ Bends | 1 |
| 5 | 18399 | 3/8″ & 1/2″ Spacer | 1 |
| 6 | 18400 | (PS) Shock Mount | I |
| 7 | 985-24-068 | Fox Shock – 985-24-068 | 2 |
| 8 | 18402 | “K” Shock Strap | I |
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>