Afrimart JT30L-CLD Cleaning Drone User Manual
- June 16, 2024
- Afrimart
Table of Contents
User manual
Preparation before use
1.1 Battery fully charged
1.2 Unfold the aircraft and propeller and lock the folder sleeve
1.3 Calibrate IMU and magnetic compass (see video tutorial for details)
1.4 Fixed injection pipe
Flying and cleaning functions
2.1 Unlock.
Switch stick E in left position, push two sticks to bottom as below until
motors start running at the same time, then release back to central position,
the motor will keep idle running speed.
2.2 Flight control
Left stick:
Up and down of the rocker corresponds to the aircraft ascending and descending
Moving the joystick to the left and right corresponds to the aircraft turning
left and right.
Right stick:
Up and down of the rocker corresponds to forward and backward movements of the
aircraft.
The joystick moves left and right corresponding to the aircraft moving left
and right.
A: One key return
B: water pump switch
2.3 Functional operation
Start spraying
- Press B to open the airborne water pump to 50%.
Note: Exceeding 50% may damage the equipment, and overload operation is
prohibited.
End spraying
- Turn off the ground water pump and set the controller to 800.
- Press B to turn off the onboard water pump.
2.4 Landing
Pull down the left rocker slightly to make the aircraft descend slowly. After
the aircraft touches the ground, straighten the rocker to the lowest level.
FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection againstharmful interference in a
residential installation. This equipment generates, uses and can radiateradio
frequency energy and, if not installed and used in accordance with the
instructions, maycause harmful interference to radio communications. However,
there is no guarantee thatinterference will not occur in a particular
installation. If this equipment does cause harmfulinterference to radio or
television reception, which can be determined by turning the equipmentoff and
on, the user is encouraged to try to correct the interference by one or more
of thefollowing measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 0cm between the radiator and your body.