Wood Trick WDTK035 Woodtrick Pendulum Clock Instructions

: June 16, 2024
: Wood Trick

Table of Contents

WDTK035 Woodtrick Pendulum Clock
Read User Manual Online (PDF format)
Download This Manual (PDF format)

WDTK035 Woodtrick Pendulum Clock
Instructions

WDTK035 Woodtrick Pendulum Clock

Polish each area between gear tooth on gears! Thread Part No.39, dividing a thread into two equal parts (2 meters or 79 inches each end). After that, make a knot at the bottom of Part No. 39 as shown in Picture 3.Reel up the part of the thread with the hook clockwise on the ﬁrst roller leaving 25 centimeters or 9.8 inches free.
Reel up the second part of the thread twice on the second roller counterclockwise. The clock must be hanged at a height of no less than 2 meters or 79 inches. Make sure the clock hangs vertically without being uneven!![Wood Trick WDTK035 Woodtrick Pendulum Clock

fig 20](https://manuals.plus/wp-content/uploads/2024/01/Wood-Trick-WDTK035 -Woodtrick-Pendulum-Clock-fig-20.jpg)Fill the hole with any loose substance (such as sand, ﬁne gravel, soil, etc.) in the amount of 1.200 +/-(50) gram or 2.645 +/-(0.11) pounds. In order to set the time, remove the part shown in Picture 1 and move the anchor towards the clock face. Next, set the time rotating the lower gear as shown in Picture 3. After setting the time, move the anchor back to its original position and reinsert the removed part from Picture 1.In order to wind up the clock, pull down the left thread while holding the weight!

Potential issues:	Potential causes and Solutions:
The mechanism is too stiﬀ to rotate or the pendulum stops working.	Gears and

bushings are poorly lubricated or polished.
Check if the clock maintains vertical position.
A thread is stuck in the guiding roller. Check if the pendulum maintains a proper position. Try to operate the mechanism a few times. To adjust the gears, pull the anchor towards yourself, wait until the weight is all the way down, and then wind the clock. Repeat this action a few times to ensure that the parts will work smoothly.
The clock is slow or fast.| 1. If the clock is fast, set the pendulum one or more holes down as shown in Picture 1.
2. If the clock is slow, set the pendulum one or more holes up as shown in Picture 2.

The clock does not wind up.| If the thread is tangled in the reel, inspect the reel and undo tangled thread.