ANCEL BST500 12V 24V Automotive Battery Load Tester with Printer User Guide

BST500 12V 24V Automotive Battery Load Tester with Printer

The instrument
does not turn on after connecting to the battery| 1.Test clip connecting wire (handle part) false solder or off| The handle is stuck with glue, use the air blower to blow hot handle glue sleeve, remove the glue sleeve to give the clip line for patch welding
2.Battery voltage is too low| Use a multimeter to measure whether the battery voltage is below 9V
3.Improper use, testing large voltage battery or series battery with the meter to make the components in the table burned out| Return to the factory for repair: familiar with the manual safety rules and
precautions, do not test more than 35V of voltage
Instrument key
does not work or no response| There is dust into the switch caused by poor contact or switch oxidation| Return to the factory for repair: protect your meter and try to keep dust water and oil out of the meter when using it
Test results are
inaccurate and vary greatly| The test result changes a lot basically because the test is not to remove the wire ear on the battery head The test results vary greatly because the battery is not tested by removing the ear from the battery head, and the place where it is clamped is different each time.| When testing in a car, the lugs should be removed and the test clips directly onto the battery head
The CCA value is very small| When testing the 12V battery, turn it to 24V for testing| Turn back to 12V for testing
No test result| 1.The battery voltage is lower than 11.9V and the test does not show any result| Recharge the battery and retest
2.The positive pole of the two clamps (with teeth part) are not in contact with the battery head or broken line (the tester can only distinguish 1 line is not in good contact with the fault)| Re-clip or solder
Printer paper jam| 1.The printer cover did not cover the gears on the cover roller and the gears on the printer did not connect well, resulting in two gears slipping| Cover the cover, you can hear the sound of the cover down
2.The printer cover deformation| Return to the factory to repair and replace the cover
Printer does not
print no action| 1.The print board or inductor solder joints off| Removal of the back cover soldering
2.The print board is burned or the printer is burned| Return to the factory to repair: replace the printer or print board
Printer action but
can not type the word| 1.Print paper installed in reverse| Reassemble the print paper
2.If you can print a fuzzy font, then the print paper is too thin or exposure to expire and other quality caused by| Replace the printing paper

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>