Xiamen Lujiang L3 Mini Printer User Manual
- June 16, 2024
- Xiamen Lujiang
Table of Contents
Xiamen Lujiang L3 Mini Printer
Product introduction
Power indicator status
- Steady green light: power on/standby/charge completed Red light is always on: charging/out of paper/overheating/opening the cover
- Flashing red: low battery will cause weak handwriting, please charge in time.
Replacement of consumables
- Open the cover: see the arrow direction as shown in the figure, push the upper cover down to open the cover;
- Consumables: according to the direction shown in the figure, put the heat-sensitive surface of the paper on the same side as the heat-sensitive head;
- Close the cover: after the consumables are put in, push the upper cover up as shown in the figure to close the cover.
First time using
Please open the paper compartment cover and put the printing paper on top of
the printer. After closing the paper compartment cover, the printing paper
will expose a short section of the printer, as shown in the figure:
Only one side of the printing paper can be printed. Please place the printing paper in the correct direction.
App download and settings
Mobile Download
Search “Luck Jingle” in the App Store
Settings
Double-click the power button, the printer will print out the QR code of the
bound device; add a device through the App, scan and scan the QR code to
connect to the printer
(Note: Do not search for Bluetooth printer connection in the Bluetooth
settings of the mobile phone)
Please do not touch the print head directly to avoid damage. especially after printing. do not touch the print head directly to prevent overheating and scalding.
Safety and precautions
-
There is a built-in lithium battery, please do not use it in an environment with temperatures higher than 40 ‘C; keep away from fire and other heat sources, and do not place it in the hot sun, such as closed car;
-
Children should be charged and used under the supervision of adults.
After a full charge, please make sure to pull out the charging line in time to prevent overheating, short circuit or fire;- Do not put the product in fire or water to avoid battery short circuit or fire or burn;
- The operating temperature range is O ‘c to 40 °C, please do not exceed the recommended temperature range;
- If you suspect that there is a problem with the battery, please contact the after-sales service center for assistance.
CAUTION
Risk of explosion if the battery is replaced by an incorrect type.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received.,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note : Ibis equipment has been tested and found to comply with the limits
for a Class B digital device, under part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used by the instructions, may cause
harmful interference to nid.io communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RE warming for Portable device: The device has been evaluated to meet the general RF exposure requirement. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>